New Buck Corporation 384 manual Also provide adequate clearances around air openings

B.	Set the top (long) trim panel in place on top of unit. The panel should be flat against the
	outside face of the fireplace, and standing vertically (measuring approximately 12” from the
	rear of the unit to the front area). Mark along the lower edge of the trim panel with a pencil
	to make reference line for mounting.

NOTE: If used in installation trim panels or surrounds shall not seal ventilation openings in the fireplace.

Also provide adequate clearances around air openings.

(4)Slide the unit out of the fireplace far enough to work behind the trim panel reference lines with a screw gun.

NOTE: You need to make sure the supply gas line is hooked up at this time. Be sure to check for leaks at the connection using soap and water. DO NOT USE OPEN FLAME TEST FOR LEAKS.

(5)With screws provided with fireplace kit, attach both side trim panels. Next, attach top trim panel.

(6)Slide the heater back into the fireplace with the trim panels flat against the face of the fireplace.

(7)After hooking up gas line, checking for leaks, and mounting trim panels slide heater into fireplace.

(8)Place logs on burner base as shown on pages 6-7.

(9)For gas hook-up and pressure tap test, see instruction in Section II.

NOTE: Smoke shelves, shields and baffles may be removed if attached by mechanical fasteners.

Page 21