Heat & Glo LifeStyle SUPREME-I30-SP Installing Adaptor and Termination Cap, Masonry Factory Built

F. Installing Adaptor and Termination Cap

For installation of termination cap see minimum vent heights for various pitched roofs (see Figure 8.5) .

To install adaptor see Figure 8.6.

HORIZONTAL

OVERHANG

CAUTION! Risk of Cuts/Abrasions/Flying Debris.

Wear protective gloves and safety glasses during instal- lation. Sheet metal edges are sharp.

Damper Flashing Kit (Optional)

For use with LINK-DV30B or LINK-DV4-30B Liner Kit. Note: Damper may have to be removed to use this kit.

• Run flex liners through 3 in. holes in damper flashing.

• Attach damper flashing to firebox roof with self tapping

2FT.

MIN.

GAS DIRECT VENT

TERMINATION CAP

20 INCHES MIN.	VERTICAL
LOWEST	WALL
DISCHARGE
OPENING

X

12

ROOF PITCH

IS X/ 12

H (MIN.) - MINIMUM HEIGHT FROM ROOF TO LOWEST DISCHARGE OPENING

screws included in kit.

CLASS A PIPE

Roof Pitch	H (Min.) Ft.
Flat to 6/12	....................	1.0*
Over 6/12 to 7/12		1.25*
Over 7/12 to 8/12		1.5*
Over 8/12 to 9/12		2.0*
Over 9/12 to 10/12		2.5*
Over 10/12 to 11/12		3.25

Roof Pitch	H (Min.) Ft.
Over 11/12 to 12/12		4.0
Over 12/12 to 14/12		5.0
Over 14/12 to 16/12		6.0
Over 16/12 to 18/12		7.0
Over 18/12 to 20/12		7.5
Over 20/12 to 21/12		8.0

Figure 8.6

* 3 foot minimum in snow regions

Figure 8.5 Minimum Height from Roof to Lowest Discharge Opening

To prevent odors and cold drafts, the chimney must be sealed around the vent with non-combustible blanket insulation or field fabricated metal plates.

Note: The LINK-DV4-30B

system REQUIRES this insulation.

Masonry		Factory Built
LINK-DV30B	LINK-DV4-30B
Installation	Installation	Wood Burning

	TERMINATION				OPTIONAL LINK-ZC-ADPB
	CAP				FOR USE WITH CLASS A
EXHAUST			EXHAUST		WOODBURNING PIPE
AIR			AIR
VENT PIPE			VENT PIPE
	OR			WARNING:
				DO NOT BLOCK
				THIS PIPE END!
				Note: Untwist the
				pipe while extend-
				ing it, to achieve full
				30’ length.
	INLET AIR			INLET AIR	Remove 18 inch x 18 inch flashing on cap by removing 3
				VENT PIPE
	VENT PIPE				screws. Connect both the LINK-ZC-ADPB to Class A Pipe
Figure 8.7					and the termination cap to the LINK-ZC-ADPB with the
					self tapping screws provided.
24	Heat & Glo	• Grand-I35, Grand-I35-SP, Supreme-I30, Supreme-I30-SP • 2206-900 Rev. K				• 6/11