Heat & Glo LifeStyle SUPREME-I30-SP Corner LOG Flush With Pilot Bracket, For LOG #5, For LOG #6

2206-935B

CORNER OF

LOG FLUSH

WITH PILOT

BRACKET

3

PILOT

BRACKET

Figure 5. Place Log #3

Log #3 (SRV2206-702): Position Log #3 as shown in Figure 5. Position the grate tine groove, located on the bottom of the log, over the base of the left grate tine. Pull the log forward. The back end of Log #3 rests on the log support. Move the end of Log #3 clockwise until the bottom right corner is flush with the pilot bracket.

FRONT END OF LOG		REST LOG ON
		LARGE FLAT
RESTS ON FLAT
	4	SPOT
SPOT

FLAT SPOTS

FOR LOG #5

FLAT SPOTS	POINTS OF LOG REST ON
(FOR LOG #6)
	FLAT SPOTS

5

GRATE TINE

TOUCHES

LOG GROOVE

Figure 6. Place Log #4 Figure 7. Position Log #5

Log #4 (SRV2206-703): Position Log #4 as shown in Figure 6. See Figure 3 for additional references. Place the thick end of Log #4 on the large flat spot on Log #1. Rest the front end of Log #4 on the flat spot of Log #2.

Log #5 (SRV2206-704): Position Log #5 as shown in Figure 7. See Figure 6 for additional details. Mate the grate tine with the log groove as shown. Position the tips of Log #5 on the flat spots as shown in Figure 6.

LEFT END OF	POSITION THE NOSE ON THE
LOG RESTS ON	FORK OF THE LOG
FLAT SPOT
	6

Figure 8. Position Log #6 Figure 9. Log Set Installed

Log #6 SRV(2206-706): Position Log #6 as shown in Figure 8. See Figure 7 for additional references. Rest the left end of Log #6 on the flat spot of Log #3. Position the nose of Log #6 on the fork of Log #5.

36 Heat & Glo • Grand-I35, Grand-I35-SP, Supreme-I30, Supreme-I30-SP • 2206-900 Rev. K • 6/11