9 Appliance Preparation
A. Top Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris. Wear protective gloves and safety glasses during instal- lation. Sheet metal edges are sharp.
1.Remove seal cap by lifting up and off of the starting collar.
2.Place first
WARNING! Risk of Fire! A MINIMUM of
3.Place fiberglass rope ring over initial
4.Remove bottom metal panel by removing six screws. Screw locations are shown in Figure 9.1. The four screws on the bottom side are located behind the panel. Remove all six screws and gently lift the panel off the appliance avoiding contact with the
FIBERGLASS |
ROPE RING |
BOTTOM PANEL SCREW LOCATIONS |
Figure 9.1 Location of Fiberglass Rope Ring
Heat & Glo • RED60 • | 51 |