RED60 Model With Media
This kit contains the components necessary to install the granite on single sided RED60 models that have media installed.
Kit Contents:
(3)Back panel pieces
(2)Inner side wall pieces 10 inches wide x
(2)Outside corner trim pieces. See Figure 3.
(7)Securing tabs. See Figure 4.
(7)Sheet metal screws. See Figure 4.
Tools Required:
Cordless Drill
1/4 inch hex head driver tip
Pry Bar and Hammer for opening shipping crate.
Installation
1.Begin by removing back row and sides of quarter inch sheet metal screws from base pan as shown in Figure 5. The screws will be located either on top of or underneath the mesh. If underneath mesh, lift mesh screen up and remove for access to screw heads. After removing screws replace mesh before installing granite.
Figure 1. Back Panel Pieces.
10 IN. |
Figure 2. Inner Side Wall Pieces.
Figure 3. Outside Corner Trim Pieces.
Figure 4. Securing Tabs and Sheet Metal Screws.
Figure 5. Removing Screws from Basepan.
2.Measure granite to ensure you are installing the pieces in the right orientation. Back panel pieces are to be placed first. These pieces are wider than they are tall. Install so that width is
Figure 6. Placing Back Panel Piece.
3.Secure granite pieces using angle tabs and screws provided. See Figure 7. Secure each piece as it is placed into position to keep it from falling while placing next piece into firebox. Continue with back middle piece and then back right side.
82 | Heat & Glo • RED60 • |