Heat & Glo LifeStyle manual 6000C, 6000C-IPI, Install the Log Assembly Log Assembly LOGS-6C

G. Install the Log Assembly Log Assembly: LOGS-6C

Models: 6000C-IPILP, 6000CBV-IPI
6000C, 6000C-IPI
FIBER BURNER TOP	LOCATING HOLES
	TAB BENT IN = NG	LOG PLACEMENT TABS
BURNER SHIELD	PILOT COVER	LOG PLACEMENT INDENTATIONS
BURNER ASSEMBLY
	TAB NOT BENT = LP
GUIDE SLEEVES		GRATE TINE
Figure 1		Figure 2. Log Placement Tabs

CAUTION: Logs are fragile, handle with care. Log #1 (SRV2164-701): Locate log placement tabs on the pilot cover. Bend tabs upward as shown in Figure 2. Locate the log placements slots on the bottom of Log # 1 (see Figure 3). Mate the slots located on the bottom of Log #1 with the log placement tabs on the pilot cover. Log # 1 is properly installed when it sits squarely and completely on pilot cover with tabs engaged (see Figure 4).

Figure 3

LOG PLACEMENT SLOTS

LOG PLACEMENT TABS

1

Figure 4

Figure 4 shows the log placement tabs located on the top of Log # 1. The tabs will be mated with the slots located on the bottom of Log #2 and Log #3 (see Figure 5). Log #2 and Log #3 also have grooves that allow the logs to be seated properly on the grate (see Figure 5). Hold Log #1 upright while placing Log #2.

Bottom view of

Logs # 2 and 3

LEFT GRATE TINE

SLOTS

32

GROOVES

Figure 5

2

Figure 6

1

Log #2 (SRV2164-702): Mate the slot located on the bottom of Log #2 with the left tab on top of Log #1. After slot and tab have been fitted together, mate the groove located on the bottom of Log #2 with the horizontal grate bar and slide Log # 2 toward the left until it rests against the far left grate tine.

62 Heat & Glo • 6000C, 6000C-IPI, 8000C, 8000C-IPI • 2164-900 Rev. T • 9/12