Heat & Glo LifeStyle 6000 GDVFL, 6000 XLS manual Continue Adding Vent Components

Page 16

13

WARNING

ENSURE THAT THE FIBERGLASS

ROPE GASKET SUPPLIED WITH THE

FIREPLACE SEALS BETWEEN THE

FIRST VENT COMPONENT AND THE

OUTER FIREPLACE WRAP.

If the installation is for a termination cap attached directly to the fireplace, skip to the sections, Install Firestops and Vent Termination.

2. Continue Adding Vent Components

To continue adding vent components in accordance with the pre-planned vent system configuration:

•Ensure that each succeeding vent component is securely fitted and locked into the preceding com- ponent in the vent system.

90° elbows may be installed and rotated to any point around the preceding component’s vertical axis. If an elbow does not end up in a locked position with the preceding component, attach with a minimum of two

(2) sheet metal screws.

Continue adding vent components, locking each succeeding component into place.

Figure 11. Adding Venting Components

3. Install Support Brackets

For Horizontal Runs - The vent system must be supported every five (5) feet of horizontal run by a horizontal pipe support.

To install support brackets for horizontal runs:

•Place the pipe supports around the vent pipe.

•Nail the pipe supports to the framing members.

Image 16

Contents Heat-N-Glo Fireplace Safety and Warning Information Table of Contents Replacement PartsInstallation Codes High Altitude InstallationsApprovals and Codes CodesGetting Started Diagram of the6000 Series Installing the Fireplace StepLocating FireplaceModel Models Step Framing Fireplace26-1/4 Step Installing Vent System Vent System ApprovalsDV-90D Corner Installation Venting with One 90 Elbow Venting with Two 90 Elbows Venting with three 90 elbows Installing Vent Components Attach the First Vent Component to the Starting CollarsAdding Venting Components Install Support Brackets Continue Adding Vent ComponentsInstalling Support Brackets 4. Install Firestops 12 Hole and Vent Pipe 11 Hole and New Framing Members Vent Termination Attic FirestopRound and Trapezoid Termination Caps If Exterior Walls are Finished with Major U.S. Building Codes Minimum Height from Roof to Lowest Discharge Opening Step Positioning Leveling, Securing Fireplace Step Gas Control SystemsStanding Pilot Ignition System Direct Spark Ignition DSI SystemStep Gas Supply Line Mm hook-up at the unitStep Gas Pressure Requirements Pressure Natural Gas PropaneStep Wiring Fireplace For Standing Pilot Ignition WiringOptional Accessories Remote Wall SwitchFor Direct Spark Ignition DSI Wiring Fan Wiring DiagramDirect Spark Ignition DSI Wiring Diagram Step FinishingInstalling the Trim Step Installing Trim Logs, Ember MaterialHearth Extensions Save the log instructions with this manual Positioning the LogsPlacing the Ember Material Glass Assembly Step Before Lighting Fireplace After Installation Review safety warnings and cautionsDouble-check for faulty components Double-check for gas leaksFireplace Maintenance Maintaining and Servicing Your FireplaceBurner Flame Patterns Replacement Parts Accessories Standing Pilot OnlyDSI Ignition Only 20 X Both Standing Pilot and DSI Ignition6000XLS 20 X Models Mesh