Heat & Glo LifeStyle 6000 XLS, 6000 GDVFL manual Glass Assembly

Page 33

1.Lift the trim door up and out of the unit.

2.Remove the wing nuts, glass clips, and the glass door from the unit.

CAUTION

1.Place the ember material onto the top of the burner.

CAUTION

Figure 29. Glass Assembly

HAND TIGHTEN THE WING NUTS, BUT BE CAREFUL NOT TO OVERTIGHTEN.

Figure 30. Placement of the Ember Material

IT IS STRONGLY RECOMMENDED THAT TRIM DOORS WITH OPTIIONAL MESH SCREENS BE INSTALLED ON PROPANE MODELS.

30

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Heat-N-Glo Fireplace Safety and Warning Information Replacement Parts Table of ContentsHigh Altitude Installations Installation CodesApprovals and Codes CodesGetting Started Diagram of the6000 Series Step Installing the FireplaceLocating FireplaceStep Framing Fireplace Model Models26-1/4 Vent System Approvals Step Installing Vent SystemDV-90D Corner Installation Venting with One 90 Elbow Venting with Two 90 Elbows Venting with three 90 elbows Attach the First Vent Component to the Starting Collars Installing Vent ComponentsContinue Adding Vent Components Adding Venting Components Install Support BracketsInstalling Support Brackets 4. Install Firestops 12 Hole and Vent Pipe 11 Hole and New Framing Members Attic Firestop Vent TerminationRound and Trapezoid Termination Caps If Exterior Walls are Finished with Major U.S. Building Codes Minimum Height from Roof to Lowest Discharge Opening Step Gas Control Systems Step Positioning Leveling, Securing FireplaceStanding Pilot Ignition System Direct Spark Ignition DSI SystemMm hook-up at the unit Step Gas Supply LinePressure Natural Gas Propane Step Gas Pressure RequirementsFor Standing Pilot Ignition Wiring Step Wiring FireplaceOptional Accessories Remote Wall SwitchFan Wiring Diagram For Direct Spark Ignition DSI WiringStep Finishing Direct Spark Ignition DSI Wiring DiagramStep Installing Trim Logs, Ember Material Installing the TrimHearth Extensions Positioning the Logs Save the log instructions with this manualPlacing the Ember Material Glass Assembly Review safety warnings and cautions Step Before Lighting Fireplace After InstallationDouble-check for faulty components Double-check for gas leaksMaintaining and Servicing Your Fireplace Fireplace MaintenanceBurner Flame Patterns Standing Pilot Only Replacement Parts AccessoriesDSI Ignition Only Both Standing Pilot and DSI Ignition 20 X6000XLS 20 X Models Mesh
Top Page Image Contents