Heat & Glo LifeStyle 6000 GDVFL manual Step Wiring Fireplace, For Standing Pilot Ignition Wiring

Page 28

Step 8

Wiring the

Fireplace

CAUTION

NOTE: Electrical wiring must be installed by a licensed electrician.

Caution: Disconnect remote controls if you are absent for extended time periods. This will prevent accidental fireplace operation.

For Standing Pilot Ignition Wiring

Appliance Requirements

•This appliance DOES NOT require 110-120 VAC to operate.

WARNING

DO NOT CONNECT 110-120 VAC TO THE GAS CONTROL VALVE OR REMOTE WALLSWITCH ORTHEAPPLIANCE WILL MALFUNCTIONAND THE VALVE WILLBE DESTROYED.

Optional Accessories

Optional fan and remote control kits require that 110- 120 VAC be wired to the factory installed junction box before the fireplace is permanently installed.

Remote Wall Switch

Position the remote wall switch in the desired position on a wall. Run a maximum of 25 feet (7.8 m) or less length of 18 A.W.G. minimum wire and connect it to the fireplace ON/OFF switch pigtails.

WARNING

DO NOT CONNECT 110-120 VAC TO THE REMOTE WALL SWITCH OR THE CONTROLVALVE WILLBE DESTROYED.

LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DANGEROUS OPERATION. VERIFY PROPER OPERATION AFTER SERVICING.

25

Figure 24. Standing Pilot Ignition Wiring Diagram

Image 28

Contents Heat-N-Glo Fireplace Safety and Warning Information Table of Contents Replacement PartsInstallation Codes High Altitude InstallationsApprovals and Codes CodesGetting Started Diagram of the6000 Series Installing the Fireplace StepLocating FireplaceModel Models Step Framing Fireplace26-1/4 Step Installing Vent System Vent System ApprovalsDV-90D Corner Installation Venting with One 90 Elbow Venting with Two 90 Elbows Venting with three 90 elbows Installing Vent Components Attach the First Vent Component to the Starting CollarsAdding Venting Components Install Support Brackets Continue Adding Vent ComponentsInstalling Support Brackets 4. Install Firestops 12 Hole and Vent Pipe 11 Hole and New Framing Members Vent Termination Attic FirestopRound and Trapezoid Termination Caps If Exterior Walls are Finished with Major U.S. Building Codes Minimum Height from Roof to Lowest Discharge Opening Step Positioning Leveling, Securing Fireplace Step Gas Control SystemsStanding Pilot Ignition System Direct Spark Ignition DSI SystemStep Gas Supply Line Mm hook-up at the unitStep Gas Pressure Requirements Pressure Natural Gas PropaneStep Wiring Fireplace For Standing Pilot Ignition WiringOptional Accessories Remote Wall SwitchFor Direct Spark Ignition DSI Wiring Fan Wiring DiagramDirect Spark Ignition DSI Wiring Diagram Step FinishingInstalling the Trim Step Installing Trim Logs, Ember MaterialHearth Extensions Save the log instructions with this manual Positioning the LogsPlacing the Ember Material Glass Assembly Step Before Lighting Fireplace After Installation Review safety warnings and cautionsDouble-check for faulty components Double-check for gas leaksFireplace Maintenance Maintaining and Servicing Your FireplaceBurner Flame Patterns Replacement Parts Accessories Standing Pilot OnlyDSI Ignition Only 20 X Both Standing Pilot and DSI Ignition6000XLS 20 X Models Mesh