Heat & Glo LifeStyle 6000 XLS, 6000 GDVFL manual Round and Trapezoid Termination Caps

Page 21

For round cap termination:

1. Secure the 8-5/8 inch

(219 mm) pipe, using the exterior pipelock hole on the round flange of the wall firestop.

For trapezoidal termination:

1.Screw the cap to the exterior wall through the flanges in the cap.

2.Seal the joint between the pipe and the

exterior firestop.

Figure 18. Round and Trapezoid Termination

Caps

WARNING

THE BOTTOM OF THE VENT

TERMINATION CAP MUST BE A

MINIMUM OF 12 INCHES (305 MM)

ABOVE GROUND LEVEL (GRADE). THE

TOP OF THE CAP MUST BE A MINIMUM

OF 18 INCHES (457 MM) BELOW

COMBUSTIBLE MATERIAL, SUCH AS A

DECK, AND THE SIDE OF THE CAP

MUST BE A MINIMUM OF 6 INCHES (152

MM)AWAY FROM A PARALLEL OUTSIDE WALL. VENTING TERMINALS SHALL NOT BE RECESSED INTO A WALL OR SIDING. SEE THE FOLLOWING DIAGRAM FOR VENT TERMINATION CLEARANCES.

18

Image 21

Contents Heat-N-Glo Fireplace Safety and Warning Information Replacement Parts Table of ContentsHigh Altitude Installations Installation CodesApprovals and Codes CodesGetting Started Diagram of the6000 Series Step Installing the FireplaceLocating FireplaceStep Framing Fireplace Model Models26-1/4 Vent System Approvals Step Installing Vent SystemDV-90D Corner Installation Venting with One 90 Elbow Venting with Two 90 Elbows Venting with three 90 elbows Attach the First Vent Component to the Starting Collars Installing Vent ComponentsContinue Adding Vent Components Adding Venting Components Install Support BracketsInstalling Support Brackets 4. Install Firestops 12 Hole and Vent Pipe 11 Hole and New Framing Members Attic Firestop Vent TerminationRound and Trapezoid Termination Caps If Exterior Walls are Finished with Major U.S. Building Codes Minimum Height from Roof to Lowest Discharge Opening Step Gas Control Systems Step Positioning Leveling, Securing FireplaceStanding Pilot Ignition System Direct Spark Ignition DSI SystemMm hook-up at the unit Step Gas Supply LinePressure Natural Gas Propane Step Gas Pressure RequirementsFor Standing Pilot Ignition Wiring Step Wiring FireplaceOptional Accessories Remote Wall SwitchFan Wiring Diagram For Direct Spark Ignition DSI WiringStep Finishing Direct Spark Ignition DSI Wiring DiagramStep Installing Trim Logs, Ember Material Installing the TrimHearth Extensions Positioning the Logs Save the log instructions with this manualPlacing the Ember Material Glass Assembly Review safety warnings and cautions Step Before Lighting Fireplace After InstallationDouble-check for faulty components Double-check for gas leaksMaintaining and Servicing Your Fireplace Fireplace MaintenanceBurner Flame Patterns Standing Pilot Only Replacement Parts AccessoriesDSI Ignition Only Both Standing Pilot and DSI Ignition 20 X6000XLS 20 X Models Mesh