Heat & Glo LifeStyle 6000 GDVFL manual Step Finishing, Direct Spark Ignition DSI Wiring Diagram

Page 30

Figure 26. Direct Spark Ignition (DSI) Wiring Diagram

27

Step 9

Finishing

Only non-combustible materials may be used to cover the black fireplace front.

The following diagram shows the minimum vertical and corresponding maximum horizontal dimensions of fireplace mantels or other combustible projections above the top front edge of the fireplace. See Figures 2 and 3 for other fireplace clearances.

12"

11"

10"

7"

8"

9"

5"

6"

11"

10"

4"

7"

8"

9"

2"

3"

6"

4.5"

5"

1"

3"

3.5"

4"

1.5"

TOP FRONT EDGE

OF FIREPLACE

NOTE: ALL DIMENSIONS SHOWN

IN INCHES.

Figure 27. Minimum Vertical and Maximum Horizontal Dimensions of Combustibles above Fireplace

WARNING

WHEN FINISHING THE FIREPLACE, NEVER OBSTRUCT OR MODIFY THE AIR INLET/OUTLET GRILLES IN ANY MANNER.

Image 30

Contents Heat-N-Glo Fireplace Safety and Warning Information Table of Contents Replacement PartsApprovals and Codes Installation CodesHigh Altitude Installations CodesGetting Started Diagram of the6000 Series Locating Installing the FireplaceStep FireplaceStep Framing Fireplace Model Models26-1/4 Step Installing Vent System Vent System ApprovalsDV-90D Corner Installation Venting with One 90 Elbow Venting with Two 90 Elbows Venting with three 90 elbows Installing Vent Components Attach the First Vent Component to the Starting CollarsAdding Venting Components Install Support Brackets Continue Adding Vent ComponentsInstalling Support Brackets 4. Install Firestops 12 Hole and Vent Pipe 11 Hole and New Framing Members Vent Termination Attic FirestopRound and Trapezoid Termination Caps If Exterior Walls are Finished with Major U.S. Building Codes Minimum Height from Roof to Lowest Discharge Opening Standing Pilot Ignition System Step Positioning Leveling, Securing FireplaceStep Gas Control Systems Direct Spark Ignition DSI SystemStep Gas Supply Line Mm hook-up at the unitStep Gas Pressure Requirements Pressure Natural Gas PropaneOptional Accessories Step Wiring FireplaceFor Standing Pilot Ignition Wiring Remote Wall SwitchFor Direct Spark Ignition DSI Wiring Fan Wiring DiagramDirect Spark Ignition DSI Wiring Diagram Step FinishingStep Installing Trim Logs, Ember Material Installing the TrimHearth Extensions Positioning the Logs Save the log instructions with this manualPlacing the Ember Material Glass Assembly Double-check for faulty components Step Before Lighting Fireplace After InstallationReview safety warnings and cautions Double-check for gas leaksFireplace Maintenance Maintaining and Servicing Your FireplaceBurner Flame Patterns Replacement Parts Accessories Standing Pilot OnlyDSI Ignition Only Both Standing Pilot and DSI Ignition 20 X6000XLS 20 X Models Mesh