Design Dynamics DVF-36S-N Product Identification, Local Codes, Product Features

Page 4

Safety information

Continued

3.Never install the fireplace

in a recreational vehicle

in windy or drafty areas where curtains or other combustible (flammable) objects can make contact with the fireplace front

in high traffic areas

4.Turn fireplace off and let cool before servicing, installing or repairing. Only a qualified service person should install, service or repair this fireplace. Have fire- place inspected annually by a qualified service person.

5.You must keep control compartments, burners and circulating air passages clean. More frequent cleaning may be needed due to excessive lint and dust from carpeting, bedding material, etc. Turn off the gas valve and pilot light before cleaning fireplace.

6.Have venting system inspected annually by a qualified service person. If needed, have venting system cleaned or repaired. See Cleaning and Maintenance, page 23.

7.Do not use any solid fuels (wood, coal, paper, cardboard, etc.) in this fireplace. Use only the gas type indicated on fire- place nameplate.

8.This appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.1.

9.Do not use fireplace if any part has been exposed to or under water. Immediately call a qualified service person to arrange for replacement of the unit.

10.Do not operate fireplace if any log is broken.

11.Do not operate fireplace with glass door removed, cracked or broken.

12.Provide adequate clearances around air openings.

Product

Identification

Nailing

Flue

Collar

Flange

 

Outer

Glass

Door

Aniron

Standard

Brick

Refractories

Center Brick/

Control Cover Log Set

Figure 1 - Direct Vent Fireplace

(DVF-36SC Shown)

Local Codes

Install and use fireplace with care. Follow all local codes. In the absence to local codes, use the current National Fuel Gas Code ANSI Z223.1/NFPA 54* (USA) or the current CSA- B149.1 Installation Code (Canada).

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

Product Features

These are a few facts that can help you under- stand and enjoy your direct vent fireplace:

The venting system may be routed to the outside of your home in several ways. It may vent through the roof (vertical) or it may vent to an outside/exterior wall (hori- zontal). The vent pipe installation is very important to allow for proper operation. You must follow the venting instructions very carefully for either vertical or horizontal applications.

www.desatech.com120441-01A

Image 4
Contents Propane/LP Gas Models Gas Models NaturalStacked Brick/Standard Glass Table of Contents Safety InformationNatural and Propane/LP Gas Natural This fireplaceProduct Identification Product FeaturesLocal Codes Preinstallation InstallationLocation and space requirements Proper clearances must be maintainedClearances Framing and finishingFor specific venting ClearancesLocation of Termination Cap Balcony with Perpendicular Side WallVenting Installation Installation PrecautionsInstallation Planning Twist-Lock Procedure The femaleSee , Apply Mastic to All Four Sides Vent Cap Wood ScrewTo All Four Sides Horizontal High Wind Square Termination Elbow Wall FirestopMax max max Vertical Termination Installation Flat Ceiling InstallationOutside Air Flex Installation High Altitude InstallationVertical Venting = 40 maxFireplace Installation Parts list for venting kits and componentsInstalling Gas Piping to Fireplace Location Check GAS TypeGas Connection Connecting Fireplace to GAS Supply Checking GAS ConnectionsPsig 3.5 kPa will damage fireplace gas regulator Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPaPressure Testing Fireplace Gas Connections Installing Middle Door DVF-36SC/HC Models OnlyInstalling Outer Door DVF-36SC/HC Models Only FireplaceSee , Follow these instructions in reverse to reinstall Spring Loaded Pin Pin Located on Middle DoorHook LocatedOuter Door Hinge On Inner Door Middle Door Remove screen and rod see ,Lava Rock, Ember Flakes Scrap Log Installation Side Bricks Side Trim Screen Rod LeftBottom Brick Middle Bottom Brick Right Bottom BrickWall Switch Installation Remote control Installation Model WRCWiring Diagram For your safety Read before lightingOperation Lighting InstructionsPilot Assembly Inspecting BurnersTo Turn OFF GAS To Appliance Remote OperationCleaning Maintenance Glass DoorsTechnical Service SpecificationsReplacement Parts Service HintsTroubleshooting Observed Problem Possible Cause Remedy21 and/or check ground wire to ignition module Pilot will not stay litTo ignition module and/or Poor ground to ignitionTions, ConfigurationGlass soots Debris around burner air Illustrated Parts Breakdown Parts List Not a field replaceable partIllustrated parts breakdown Bottom Pan Weldment Illustrated parts breakdown 120168-01 Refractory Trim, RH 120168-02 Refractory Trim, LH 120441-01A 120441-01A Warranty Information Keep this WarrantyLimited Warranty Direct vent Fireplace