Design Dynamics DVF-36S-N installation manual Table of Contents, Safety Information

Page 2

Table of Contents

Safety Information

2

Inspecting Burners

22

Product Identification

4

Cleaning and Maintenance

23

Local Codes

4

Specifications

24

Product Features

4

Replacement Parts

24

Preinstallation

5

Service Hints

24

Location of Termination Cap

7

Technical Service

24

Venting Installation

8

Troubleshooting

25

Fireplace Installation

14

Illustrated Parts Breakdown and Parts List

28

Wiring Diagram

21

Warranty Information

Back Cover

Operation

21

 

 

 

Safety Information

WARNING: Improper instal- lation, adjustment, alteration, service or maintenance can causeinjuryorpropertydamage. Refer to this manual for correct installation and operational procedures. For assistance or additional information consult a qualified installer, service agency or the gas supplier.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases, unless a certified kit is used.

State of Massachusetts: The installation must be made by a licensed plumber or gas fitter in the Commonwealth of Mas- sachusetts.

WARNING: This product contains and/or generates chemicals known to the State of California to cause cancer or birth defects or other reproduc- tive harm.

IMPORTANT: Read this owner’s manual carefully and completely before trying to assemble, op- erate or service this fireplace. Improper use of this fireplace cancause serious injury or death from burns, fire, explosion, electrical shock and carbon monoxide poisoning.

DANGER: Carbon monoxide poisoning may lead to death!

This vented gas fireplace is a sealed combus- tion gas fireplace designed for residential applications. This fireplace must be installed with DESA vent pipe components and ter- minations.

Outside airflex installation is required for both horizontal and vertical installation.

This fireplace complies with the National Safe- ty Standards and is listed and tested by OMNI Test Laboratories, Inc. to ANSI Z21.50b-2005

standard as vented gas fireplace.

This fireplace must be installed by a qualified (certified or licensed) service person. It brings in fresh air for combustion through the outer pipe and combustion gases are exhausted through the inner pipe. If the glass door as- sembly and venting pipe are not properly seated, connected and sealed, carbon mon- oxide leakage (spillage) can occur.

www.desatech.com120441-01A

Image 2
Contents Stacked Brick/Standard Glass NaturalPropane/LP Gas Models Gas Models Table of Contents Safety InformationNatural and Propane/LP Gas Natural This fireplaceLocal Codes Product FeaturesProduct Identification Location and space requirements PreinstallationInstallation Proper clearances must be maintainedFor specific venting ClearancesFraming and finishing ClearancesLocation of Termination Cap Balcony with Perpendicular Side WallVenting Installation Installation PrecautionsInstallation Planning Twist-Lock Procedure The femaleTo All Four Sides Apply Mastic to All Four Sides Vent Cap Wood ScrewSee , Max max max Elbow Wall FirestopHorizontal High Wind Square Termination Vertical Termination Installation Flat Ceiling InstallationVertical Venting Outside Air Flex InstallationHigh Altitude Installation = 40 maxInstalling Gas Piping to Fireplace Location Fireplace InstallationParts list for venting kits and components Check GAS TypeGas Connection Psig 3.5 kPa will damage fireplace gas regulator Connecting Fireplace to GAS SupplyChecking GAS Connections Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPaInstalling Outer Door DVF-36SC/HC Models Only Pressure Testing Fireplace Gas ConnectionsInstalling Middle Door DVF-36SC/HC Models Only FireplaceOuter Door Hinge On Inner Door Middle Door See , Follow these instructions in reverse to reinstallSpring Loaded Pin Pin Located on Middle DoorHook Located Remove screen and rod see ,Bottom Brick Lava Rock, Ember Flakes Scrap Log InstallationSide Bricks Side Trim Screen Rod Left Middle Bottom Brick Right Bottom BrickWall Switch Installation Remote control Installation Model WRCOperation Wiring DiagramFor your safety Read before lighting Lighting InstructionsTo Turn OFF GAS To Appliance Pilot AssemblyInspecting Burners Remote OperationCleaning Maintenance Glass DoorsReplacement Parts Technical ServiceSpecifications Service HintsTroubleshooting Observed Problem Possible Cause RemedyTo ignition module and/or 21 and/or check ground wire to ignition modulePilot will not stay lit Poor ground to ignitionGlass soots Debris around burner air ConfigurationTions, Illustrated Parts Breakdown Parts List Not a field replaceable partIllustrated parts breakdown Bottom Pan Weldment Illustrated parts breakdown 120168-01 Refractory Trim, RH 120168-02 Refractory Trim, LH 120441-01A 120441-01A Limited Warranty Warranty InformationKeep this Warranty Direct vent Fireplace