Operating Instructions, Glass Information

Chateau™ Decorative Gas Appliance

Operating Instructions

Glass Information

Only glass approved by CFM Corporation should be used on this ﬁreplace.

•The use of any non-approved replacement glass will void all product warranties.

•Care must be taken to avoid breakage of the glass.

•Do not operate appliance with glass front removed, cracked or broken.

•A replacement glass frame assembly (complete with gasket) is available through your CFM Corporation dealer and should only be installed by a licensed qualiﬁed service person.

Glass Frame Assembly Removal

1.Turn the ﬁreplace OFF (including the pilot).

2.If the unit has been operating allow time for the components to cool.

3.Using a Phillips screwdriver, unfasten two (2) screws located at the top of the glass frame. (Fig. 38)

4.Tilt the glass frame at the top away from the unit. Lift it carefully off the bottom door track and set on padded surface.

Phillips

Screws

FP1469a

Fig. 38 Remove Phillips screws, tilt frame forward and lift off bottom door track.

Glass Cleaning

It is necessary to periodically clean the glass. During start-up, condensation, which is normal, forms on the inside of the glass. This condensation causes lint, dust and other airborne particles to cling to the glass surface.

Also initial paint curing may deposit a slight ﬁlm on the glass. It is therefore recommended the glass be cleaned two or three times with a non-ammonia based household cleaner and warm water (gas ﬁreplace glass cleaner is recommended) within the ﬁrst few weeks of operation.

After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment in the house.

Clean the glass after the ﬁrst two weeks of operation.

Restrictor Plates Installation

Refer to Page 12 for your venting conﬁguration and combination of restrictor plate requirement.

Restrictor Plate Installation

Using the two (2) screws provided along with the restic- tor plate shipped with the logset, fasten the restrictor plate to the ﬁrebox top through the front of the unit. (Fig. 39)

	Flue Opening
	Restric-
	tor Plate
	Sheet Metal
	Screws
	DVT38S2
	Use tin snips to cut
	along slots to make 4¹⁄₂”
	(114mm) restrictor plate.
	(Refer to Page 18, Fig.
FP1364	29)

Fig. 39 Restrictor plate location.

20009543