
8.Position the log left grate. (Fig. 47) Hold the log with your left hand with the pointed end toward the right and the flat surface facing down. Set the log on the inside of the fettle toward the left over the overlay and hook the branch and the pointed end of the log through the first and second opening on the fettle by using the second and third tine. When the log is in place, it will be sitting at an angle in the air above the overlay. Repeat this step for opposite side.
Log Left Grate
LG427
Log Left Grate
Fig. 47 Position log left grate.
9.Position the log middle. (Fig. 49) Familiarize yourself with notches located on the flat surface of the log on each end. (Fig. 48) These notches are utilized in positioning the log. Hold the log with the flat surface facing down and the burned out end closer to you.
NOTE: Position this log through the side with the con- trol valve box on the left side. Set the log using the notches mentioned earlier located on the flat surface of the log and using the fourth “middle” tine on each fettle. When the log is in place, the notches located on the bottom of the log will set directly above the fourth “middle” tine on each fettle.
Bottom View
Notch
NOTE: These notches will fit onto the fourth middle tine of each fettle.
Chateau™ Decorative Gas Appliance
Log Middle
LG429
Fourth “Middle” Tine
Fig. 49 Position log middle.
10.Position the log right grate. (Fig. 50) Hold the log with your right hand with the pointed end toward the left and the flat surface facing down. Hook the notch located on the right corner of the log through the first opening on the right hand side of the fettle using the first tine. Bring the log toward you until it comes in contact with the fettle. Then rest the pointed end over the middle log positioned in Step 9. Repeat this step for opposite side.
Log Right Grate
LG430
Fig. 50 Position log right grate.
11. Position the log front right. (Fig. 51) Hold the log |
with the two (2) branches toward you. Set the left |
branch on the inside of the second tine of the fettle |
and drop the right branch on the overlay behind the |
log positioned in Step 7. Lay the other end of the log |
over the notch located on the log positioned in Step |
10. Make sure to clear the opening on the overlay |
when looking straight down. |
12. Position the log front upper right. (Fig. 52) Hold the |
log with narrow end toward you. Set the narrow end |
over the flat notch on the log right grate positioned |
in Step 10. Lay the wide end of the logs over the |
Notch
LG428
branch on the log left grate positioned in Step 8. |
Fig. 48 Use notches on bottom side of log to set in place.
20009543 | 25 |