Vermont Casting DVT38S2 Lighting and Operating Instructions, Lighting Instructions, Valve

Page 29

Chateau™ Decorative Gas Appliance

Lighting and Operating Instructions

For Fireplaces equipped with SIT822 Gas Valve (EN or EP) Warning: If you do not follow these instructions exactly, a fire or explosion

may result causing property damage, personal injury and loss of life.

FOR YOUR SAFETY READ THE FOLLOWING WARNINGS

BEFORE LIGHTING THE APPLIANCE

A.This fireplace is equipped with an ignition device which automatically lights the pilot. DO NOT try to light the pilot by hand.

B.BEFORE OPERATING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than the air and will settle on the floor.

What to do if you smell gas

Do not try to light any appliance

Do not operate any electrical switch.

Do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone.

Follow the gas suppliers instructions.

If you cannot contact your gas supplier call the Fire Department

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand do not try to repair it, call a qualified service technician. Force or attempting repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and replace any part of the control system and any gas control that has been under water.

Lighting Instructions

1.STOP! Read the safety information above and locate the control panel before continuing.

2.Turn off all electrical power to the appliance.

3.This appliance is equipped with an ignition device which automatically lights the pilot. DO NOT try to light the pilot by hand.

4.Access the gas control by lowering the lower access door (louvre assembly).

HI

5.Turn the remote switch, if used, OFF. Turn the wireless remote, if used, OFF.

6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas STOP. Follow instructions B in the safety warnings above. If you do not smell gas go onto the next step.

7.Close the access door.

8.Turn ON all electrical power to the appliance.

9.Turn remote switch or wireless remote to “ON”.

10.If the appliance will not operate, follow the instructions TURNING OFF THE GAS TO THE APPLIANCE and call your service technician or gas supplier.

Turning Off the Gas to the Appliance

1.Turn the remote switch to the “OFF” position.

2.Turn OFF all electrical power to the fireplace if service is required.

3.Open the lower access panel.

4.Turn the shut-off valve on the gas line to the “OFF” position.

Valve in the

1/2” NPT x 1/2”

“ON” position

Flare Shut-Off

Valve

 

3/8” Gas Tight or

Tinned Copper (From Valve)

1/2” Gas Supply

20009543

29

Image 29
Contents What to do if YOU Smell GAS INSTALLER/CONSUMER Safety InformationTable of Contents Please Review the Following Carefully Installation & Operating InstructionsLocating Your Fireplace Standard Framing DimensionMantel Surround Framing CriticalHearth Clearance to CombustiblesMantels Nailing flanges Framing and FinishingFinal Finishing Gas Line InstallationGas Specifications Gas Inlet and Manifold PressuresElectronic Gas Control Valve Remote ON/OFF SwitchElectrical Junction Box E Units Only Location of Vent Termination General VentingGeneral Venting Information Termination Location Canadian Installations1 US Installations2General Information Assembling Vent Pipes SK8 Venting Pipes Canadian InstallationsUSA Installations Horizontal Termination Restrictor Plate GuideVertical Termination ApplicationMm on the bottom Sidewall ApplicationsStep Sidewall InstallationAlways install horizontal venting on a level plane Horizontal length requirement Sidewall Installation with Stationary Glass Facing OutsideInstallation Procedure Installing the 38S2VDK DoorRestrictor plate use in straight up installation Turn shutter plate over to cover opening Installing firestop spacer Vertical Through-the-Roof InstallationMin 610mm Component Description Model Number Chimney ComponentsGlass Cleaning Glass Frame Assembly RemovalRestrictor Plates Installation Operating InstructionsLog, Lava Rock and Ember Placement Ceramic Refractory InstallationLava rock and ember placement Position the log front right. Hold the log RN/RP & EN/EP Models Flame & Temperature AdjustmentFlame Characteristics Trim frame in place Trim InstallationTo Turn Off Gas To Heater Lighting and Operating InstructionsLighting Instructions Lighting and Operating InstructionsTurning Off the Gas to the Appliance ValveSIT Nova 820 Millivolt Valve Troubleshooting the Gas Control SystemSIT 822 Valve with a Honeywell Electronic Ignitor Conversion Procedure Conversion PrecautionsFuel Conversion Instructions Allow unit to cool if it has been operatingReplace regulator Pilot Flame AdjustmentCleaning the Standing Pilot Control System MaintenanceCleaning Electronic Ignition System Battery Replacement for Ignitor ModuleDVT38S2 Decorative Gas Appliance DVT38S2 DVT38S2Fuel Conversion Kits DVT38Remote Controls AccessoriesFull Surround Mantel Model Functions ControlledProduct Covered by this Warranty Limited Lifetime WarrantyModel EnerGuide Ratings Fireplace Efficiency % Efficiency Ratings