Secondary Installation
Installation of Panel Set:
Do not install when the unit is hot.
The brick panel set is fragile. Handle panels with care and avoid knocking them on the placement pins or any other object.
Figure 62: Brick panel bracket, slots shown.
1.Remove the two (2) screws from the rear of the baffle, use a ¼” socket or a flat head screwdriver. Place the provided brick bracket (Figure 62) at the rear of the baffle with the slots over the screw holes (see Figure 63). Insert two (2) of the provided screws into the two (2) holes along the bottom of the baffle.
|
|
|
Figure 63: Top brick panel in place, screws shown. | Figure 64: Back brick panel in place. | |
Figure 65: Side brick panels in place.
2.Remove the two (2) screws from the front of the baffle. Slide the top brick panel into the bottom bracket and place the other brick bracket over the top of the panel and line up the slots on the bracket with the holes at the top of the baffle. Use two (2) of the provided screws to hold the bracket in place. Ensure the top panel is centered before tightening the four
(4) screws completely (refer to Figure 63).
3.Slide the bottom brick panel into place under/behind the top panel bracket, the notched side is to rest on the firebox bottom. The panel should rest flush with the back of the firebox (refer to Figure 64).
4.Slide each side brick panel into place along the sides of the firebox. The panels should rest flush with the back panel and the sides of the firebox (refer to Figure 65).
37