INSTALLATION
c)Before connecting the vent pipe to the vent termination, slide the black decorative wall thimble cover over the vent pipe, then slide the Wall Penetration Heat Shield (Part #
d)Slide the appliance and vent assembly towards the wall carefully inserting the vent pipe into the riser vent terminal assem- bly. It is important that the vent pipe extends into the Riser Vent Backing Plate a suffi- cient distance so as to result in a minimum pipe overlap of
VERTICAL TERMINATION WITH CO-LINEAR FLEX SYSTEM
THE APPLIANCE MUST NOT BE
CONNECTED TO A CHIMNEY FLUE
SERVING A SEPARATE SOLID FUEL
BURNING APPLIANCE.
This appliance is designed to be attached to two 3" (76mm)
Masonry chimneys may take various contours which the flexible liner will accommo- date. However, keep the flexible liner as straight as possible , avoid unnec- essary bending.
The Air Intake pipe must be attached to the inlet air collar of the termination cap.
Diagram 5
8)Slide the decorative wall thimble up to the wall surface being careful not to scratch the paint. See diagram 5.
9)Back outside: Apply sealant to the 4" inner flue and slide the Riser Vent Front into the Backing Plate and fasten with 8 screws.
IMPORTANT:
When connecting the pipe to the Riser Vent, apply
that the vent pipe is pushed past the bead for a secure fit.
10)Seal around the outer edge of the Riser Vent Backing Plate.
Required Parts:
Part # | Description |
945G | 45o Elbow |
| Termination Cap |
3" Flex - 35 ft. | |
U27 | |
| Adapter Kit which |
| contains the following: |
Outer Pipe
Inner Pipe Adapter
Alternate Approved Caps
980 | Vertical Termination Cap |
991High Wind Cap
923GK 3"
Waterford TARA T25 Direct Vent Freestanding Gas Stove | 13 |