Regency F39-LPG, F39-NG LOG Replacement, Door Gasket, Latch Adjustment, Glass Replacement

Page 25

MAINTENANCE

LOG REPLACEMENT

The unit should never be used with broken logs. Turn off the gas valve and allow the unit to cool before opening door to carefully remove the logs. The pilot light generates enough heat to burn someone. If for any reason a log should need replacement, you must use the proper replacement log. The position of these logs must be as shown in the diagram under Log Installation.

Note: Improper positioning of logs may create carbon build-up and will alter the unit’s performance which is not covered under warranty.

DOOR GASKET

If the door gasket requires replacement use 7/8" diameter oval door gasket (Part # 650-920).

LATCH ADJUSTMENT

The door latch may require adjustment as the doorgasketmaterialcompressesafterafewfires and after glass replacement.Turn the adjustable catch to tighten or loosen the latch.

GLASS REPLACEMENT

Your Regency® stove is supplied with high tem- perature, 5 mm Neoceram ceramic glass that will withstand the highest heat that your unit will produce. In the efl ue that you break your glass byimpact,purchaseyourreplacementdoorfrom an authorized Regency® dealer only, and follow our step-by-step instructions for replacement. The glass is not sold separately, as it must be properly sealed in the door frame.

Replacement Part #

940-325/P F39 Wraparound Glass

940-322/P F39 Panel Center Glass

940-323/P F39 Panel Side Glass

WARNING:Donotoperateappliance withglasspanelsremoved,cracked orbroken.Replacementoftheglass should be done by a licensed or qualified service person.

Note: Wearing gloves will protect your hands while handling glass.

Panel Glass Replacement

1)Remove the door from the unit and place on a soft surface to prevent scratching.

2)Pull out the door gasket.

3)Remove the nuts holding the glass retainers in place.

4)Remove the glass retainers (sides, top and bottom) and the door catch plate.

5)Replace the glass. The glass must have gasketing around it.

6)Reverse the previous steps, replace the retainers and fasten with the nuts but do not overtighten, as this can break the glass. Note: the door catch plate fi ts on top of the left side retainer.

7)Put gasket glue on the retainers, but do not put glue on the screws. Replace the door gasket, the two ends butt tight together on the bottom edge of the door.

8)Replace door on the stove and check the seal.

Panel Glass Door Assembly

Wraparound Assembly Door (same glass retainers as the Panel Assembly)

Mitred Glass Replacement

Removing Glass

1)Remove the door from the unit and place on a soft surface to prevent scratching.

2)Pull out the door gasket.

3)Remove the 24 nuts holding the glass retainers in place. Do not remove the nuts underneath the retainers.

4)Remove the door catch plate.

5)Removeglassretainersonsidesfirst(3each side) then remove two center retainers.

Note: Center glass retainers are glued to center glass.

6)Remove glass from extrusions. When re- moving center glass, leave white insulation in place.

Installing Glass

1) Install both center and side glass onto extrusions as per diagram.

2)Place glass assembly into door frame.

3)Install retainers by placing 1 drop of glue where previously glued and put in place.

4)Install side retainers.

5)Install door catch plate.

6)Install the 24 nuts loosely, do not tighten yet.

Regency® F39 Room Sealed Freestanding Gas Stove

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents 05/18/06 Please Keep These Instructions For Future ReferenceRegency F39 Room Sealed Freestanding Gas Stove Unit SpecificationsTable of Contents Safety Label Specifications InstallationGeneral Safety Information Before YOU StartClearances to Combustibles Installation ChecklistLocating Your Regency GAS Stove Installation Precautions Louver InstallationSafety Precautions For the Installer Flueing IntroductionClearance k in mm Exterior Flue Termination LocationsSpace Heaters Horizontal Terminations for All Fluing Systems Fluing ArrangementsFlue Restrictor Position DV Stove Horizontal Flue KIT DV Stove Horizontal Flue KIT # 946-112 InstallationQty. Description OptionalInstallation Minimum components for a Dura-Flue Horizontal Installation Planning Your Dura-Flue InstallationDURA-FLUE Termination KIT DURA-FLUE Fluing Components988 Wall Strap 942 Wall Thimble DURA-FLUE Horizontal InstallationsPipe and elbows to the ap- pliance adaptor with View as possible.Hole previously drilled in the ceiling, and mark DURA-FLUE Vertical TerminationOffset Chart GAS Pipe Pressure TestingGAS Connection Cathedral CeilingsValve Description Aeration AdjustmentSystem Data F39 with 40mj System DataConversion Kit Contains Qty Description Conversion KIT #731-968 from NG to LPGConversion to Lower BTU Rating LOG SET InstallationPlace Front Right Log E02-45 on the two pins as shown Place the Middle Left Log B02-56 on the two pins as shownPlace Front Left Log C02-44 onto Optional Remote Control Front Door InstallationOptional Wall Thermostat Final CheckWiring Operating Instructions Normal Operating Sounds of GAS Appliances Copy of the Lighting Plate InstructionsMaintenance Instructions MaintenanceGeneral Flue Maintenance GOLD-PLATED DoorsLatch Adjustment LOG ReplacementGlass Replacement Door GasketAlternate Fan Access FAN MaintenanceTo remove F39 fan Replacing F39 FanRemoving Valve F39 Main Assembly Parts ListDescription Part# DescriptionF39 Burner & LOG Assembly Ceramic Paper 650-920 Door Gasket Kit940-323/P Side Glass 936-243 Glass GasketWarranty Lifetime Warranty

F39-LPG, F39-NG specifications

The Regency F39-LPG and F39-NG are contemporary gas fireplaces that have garnered attention for their stylish design and advanced technology. These models cater to homeowners seeking an efficient and visually appealing heating solution. Designed with both function and aesthetics in mind, the F39 series stands out for its elegant linear design, making it suitable for a variety of interior styles.

One of the distinguishing features of the F39 series is its commitment to energy efficiency. Both the F39-LPG, which operates on liquid propane, and the F39-NG, which utilizes natural gas, have been engineered to deliver optimal heat output while consuming minimal fuel. This efficiency not only reduces energy costs but also minimizes environmental impact, aligning with modern sustainable living practices.

The F39 series boasts advanced venting technology, allowing for versatile installation options. This feature enables homeowners to select the perfect location for their fireplace without compromising aesthetic appeal or functionality. The unit can be vented either vertically or horizontally, providing flexibility in design while ensuring safe and effective operation.

In terms of control, the Regency F39 models come equipped with a user-friendly remote control option. This allows for convenient operation from across the room, making it easy to adjust flame height and heat settings to create the perfect ambiance. Moreover, the models can also be connected to smart home systems, enabling homeowners to integrate their fireplace into a broader heating management system.

Aesthetically, the F39 series offers customizable options, including various media and decorative elements. Homeowners can choose from traditional logs, contemporary glass, or pebbles, allowing each unit to reflect their personal style and complement their home’s decor. The large glass viewing area enhances the visual experience, showcasing the beautiful flame patterns that add warmth and character to any room.

Durability is also a significant aspect of the design, with high-quality materials that ensure longevity and performance. The F39-LPG and F39-NG are constructed to withstand the rigors of everyday use while maintaining their sleek appearance.

In summary, the Regency F39-LPG and F39-NG fireplaces represent a blend of efficiency, technology, and elegance. With their advanced features, customizable aesthetics, and environmentally friendly operation, these models are ideal for those looking to enhance their living spaces with both warmth and style. Whether for a modern home or a more traditional setting, the F39 series is designed to meet diverse heating needs while providing a stunning focal point in any room.
Top Page Image Contents