Regency F39-NG, F39-LPG Front Door Installation, Optional Wall Thermostat, Final Check

Page 20

INSTALLATION

FRONT DOOR

INSTALLATION

(packaged separately)

1)Open the two side panels.

2)Slide the door

ontothetwohinge

 

pins making sure

 

the two pieces

 

are fl ush togeth-

er.

See diagram 1.

 

3)Close the door. The latch plate

must be cen- tered around the align- ment pin. See diagram

2.If the latch plate interferes with the cor-

ner of the stove you

may want to angle the

Diagram 1

 

plate slightly so the door

 

closes easier.

 

4)The latches should already be at the proper setting. If they are too hard or too easy to close, you may want to adjust them by loosening the latch catch. See diagram 3.

Diagram 2

OPTIONAL

WALL THERMOSTAT

A wall thermostat may be installed if desired. Connect the wires as per the wiring diagrams. Note that the wires are connected to the "TH" on the gas valve. Use table below to determine the maximum wire length:

Note: Preferable if the thermostat is installed on an interior wall.

Regency® offers an optional programmable thermostat but any 250-750 millivolt rated non- anticipator type thermostat that is CSA, ULC or UL approved may be used.

CAUTION

Do not connect the millivolt

wall thermostat wires

to the 240V wires.

Thermostat Wire Table

Recommended Maximum Lead Length

(Two-Wire) When Using Wall

Thermostat (CP-2 System)

 

Wire Size

 

 

Max. Length

 

14 GA.

15.24

m

 

16 GA.

9.75

m

 

18 GA.

6.10

m

 

20 GA.

3.66

m

 

22 GA.

2.71

m

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CAUTION

Do not connect the millivolt re-

mote control wires to

the 240V wires.

3)Install 3AAAalkaline batteries in transmitter and 4 AA alkaline batteries in the receiver. Install the receiver and its cover in the wall. Switch the remote receiver to "remote" mode. The remote control is now ready for operation.

FINAL CHECK

Before leaving this unit with the customer, the installer must ensure that the appliance is fi ring correctly. This includes:

1)Clocking the appliance to ensure the cor- rect firing rate (rate noted on label) at 15 minutes.

2)Ifrequired,adjustingtheprimaryairtoensure that the fl ame does not carbon. First allow the unit to burn for 15 min. to stabilize.

3)Check for proper draft.

CAUTION

Any alteration to the product that causes sooting or carboning that results in damage to the exterior facia is not the responsibility of the manufacturer.

5)Remove the blue plastic protective coating from the glass.

6)Test the seal around the door by placing a piece of paper between the unit and the door, close the door and try to pull the paper out. If it slips out easily, then the door is not properly sealed.Tighten or loosen the latch. See diagram 3.

Diagram 3

Note: The door latch may require adjust- ment as the door gasket material compresses after a few fires and after glass replacement. Turn the latch catch inward or outward to loosen or tighten.

OPTIONAL REMOTE

CONTROL

Use the Regency® Remote Control Kit approved for this unit. Use of other systems may void your warranty.

The remote control kit comes with a hand held transmitter, a receiver and a wall mounting plate.

1)Choose a convenient location on the wall to install the receiver and the receptacle box (protection from extreme heat is very important). Run wires from the fi replace to that location, use Thermostat Wire Table.

2)Connect the wires as per the wiring diagram above.

20

Regency® F39 Room Sealed Freestanding Gas Stove

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Please Keep These Instructions For Future Reference 05/18/06Unit Specifications Regency F39 Room Sealed Freestanding Gas StoveTable of Contents Safety Label Installation SpecificationsGeneral Safety Information Before YOU StartLocating Your Regency GAS Stove Installation ChecklistClearances to Combustibles Louver Installation Installation PrecautionsSafety Precautions For the Installer Flueing IntroductionSpace Heaters Exterior Flue Termination LocationsClearance k in mm Flue Restrictor Position Fluing ArrangementsHorizontal Terminations for All Fluing Systems DV Stove Horizontal Flue KIT # 946-112 Installation DV Stove Horizontal Flue KITQty. Description OptionalInstallation Planning Your Dura-Flue Installation Minimum components for a Dura-Flue Horizontal InstallationDURA-FLUE Termination KIT DURA-FLUE Fluing ComponentsDURA-FLUE Horizontal Installations 988 Wall Strap 942 Wall ThimblePipe and elbows to the ap- pliance adaptor with View as possible.DURA-FLUE Vertical Termination Hole previously drilled in the ceiling, and markGAS Pipe Pressure Testing Offset ChartGAS Connection Cathedral CeilingsAeration Adjustment Valve DescriptionSystem Data F39 with 40mj System DataConversion KIT #731-968 from NG to LPG Conversion Kit Contains Qty DescriptionLOG SET Installation Conversion to Lower BTU RatingPlace Front Left Log C02-44 onto Place the Middle Left Log B02-56 on the two pins as shownPlace Front Right Log E02-45 on the two pins as shown Front Door Installation Optional Remote ControlOptional Wall Thermostat Final CheckWiring Operating Instructions Copy of the Lighting Plate Instructions Normal Operating Sounds of GAS AppliancesMaintenance Maintenance InstructionsGeneral Flue Maintenance GOLD-PLATED DoorsLOG Replacement Latch AdjustmentGlass Replacement Door GasketFAN Maintenance Alternate Fan AccessTo remove F39 fan Replacing F39 FanRemoving Valve Parts List F39 Main AssemblyDescription Part# DescriptionF39 Burner & LOG Assembly 650-920 Door Gasket Kit Ceramic Paper940-323/P Side Glass 936-243 Glass GasketWarranty Warranty Lifetime

F39-LPG, F39-NG specifications

The Regency F39-LPG and F39-NG are contemporary gas fireplaces that have garnered attention for their stylish design and advanced technology. These models cater to homeowners seeking an efficient and visually appealing heating solution. Designed with both function and aesthetics in mind, the F39 series stands out for its elegant linear design, making it suitable for a variety of interior styles.

One of the distinguishing features of the F39 series is its commitment to energy efficiency. Both the F39-LPG, which operates on liquid propane, and the F39-NG, which utilizes natural gas, have been engineered to deliver optimal heat output while consuming minimal fuel. This efficiency not only reduces energy costs but also minimizes environmental impact, aligning with modern sustainable living practices.

The F39 series boasts advanced venting technology, allowing for versatile installation options. This feature enables homeowners to select the perfect location for their fireplace without compromising aesthetic appeal or functionality. The unit can be vented either vertically or horizontally, providing flexibility in design while ensuring safe and effective operation.

In terms of control, the Regency F39 models come equipped with a user-friendly remote control option. This allows for convenient operation from across the room, making it easy to adjust flame height and heat settings to create the perfect ambiance. Moreover, the models can also be connected to smart home systems, enabling homeowners to integrate their fireplace into a broader heating management system.

Aesthetically, the F39 series offers customizable options, including various media and decorative elements. Homeowners can choose from traditional logs, contemporary glass, or pebbles, allowing each unit to reflect their personal style and complement their home’s decor. The large glass viewing area enhances the visual experience, showcasing the beautiful flame patterns that add warmth and character to any room.

Durability is also a significant aspect of the design, with high-quality materials that ensure longevity and performance. The F39-LPG and F39-NG are constructed to withstand the rigors of everyday use while maintaining their sleek appearance.

In summary, the Regency F39-LPG and F39-NG fireplaces represent a blend of efficiency, technology, and elegance. With their advanced features, customizable aesthetics, and environmentally friendly operation, these models are ideal for those looking to enhance their living spaces with both warmth and style. Whether for a modern home or a more traditional setting, the F39 series is designed to meet diverse heating needs while providing a stunning focal point in any room.
Top Page Image Contents