INSTALLATION
CONVERSION KIT # 434-969 FROM NG TO LP
U32S-5 using SIT 820 NOVA Gas Valve
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
Each Kit contains one LP Conversion Kit and one DC Sparker Kit.
LP Conversion Kit Contains:
Qty. Part # | Description | |
1 | Burner Orifice #54 | |
1 | Decal "Converted to | |
|
| LPG" |
1 | Red "LPG" label | |
1 | 5/32" Allen Key | |
1 | LPG Injector | |
|
| (Pilot Orifice) |
1 | Instruction Sheet | |
DC Sparker Kit Contains: | ||
Qty. Part # | Description | |
1 | Bracket DC Sparker | |
1 | Bracket DC Sparker | |
1 | Washer #8 External Star | |
1 | Nut | |
1
1
0.500 in.
1
2
|
| "B", Black Oxide |
1 | Spark Generator | |
|
| Battery Holder |
1 | Spark Generator | |
|
| Switch C/W Wire |
1
2
1 | Wire Fan To Power Cord | |
|
| Ground 30 in. |
| Velcro Hook, Black | |
| Velcro Hook, Black |
1)Turn off the gas supply.
2)Remove the glass door.
a)Release the two hooks from the bottom of the glass door.
b)Swing the door out 45 degrees from the bottom and lift up and out.
3)Remove the burner by undoing the 2 screws as shown below.
Burner4)After screws have been removed, slide the burner to the left, then lift out carefully.
5)Remove the base cover by lifting up from the back, then maneover it out.
6)Remove burner orifice with a 1/2" wrench and discard.
Burner Orifi ce7)Install the new LP burner orifice stamped #54 and tighten.
8)Remove the pilot shield by removing the 2 screws as shown below.
11 |