Regency U32S-LP5, U32S-NG5 installation manual Fan Maintenance, Fan Removal, Burner, Door Frame

Page 25
FAN MAINTENANCE

MAINTENANCE

FAN MAINTENANCE

If your fan requires maintenance or replacement, access to the fan is through the plate on the rear wall of the firebox. NOTE: the unit MUST

NOT be operated without the fan access panel securely in place.

Caution: Label all wires prior to disconnecting when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

FAN REMOVAL

1)Turn the unit off and allow it to cool down to room temperature.

2)Disconnect the power source and turn off the gas supply to the insert.

3)Open the bottom louver.

4)Remove the door frame by lifting out from the bottom and lift up off the glass door.

5)Remove the glass door.

a)Remove the 2 hooks shown below at the bottom of the glass door.

b)Swing the door out 45o from the bottom and lift up and

out.

7)Remove the burner by undoing the 2 screws shown.

a)Carefully slide the burner to the left.

b)Then lift the burner up and out carefully, ensuring not to spill the glass crystals.

Burner

Door Frame

Glass Door

U32S-5 FPI Direct Vent Gas Insert

25

Image 25
Contents U32 Sunrise Gas Insert Installation ManualOwners 918-788TO THE NEW OWNER SAFETY LABEL TABLE OF CONTENTSMAINTENANCE PARTS LISTSAFETY LABEL MA Code - CO Detector REQUIREMENTSfor the State of Massachusetts only 5.08 Modifications to NFPA-54,ChapterU32S-5FPI Direct Vent Gas Insert UNIT DIMENSIONSFOR YOUR SAFETY INSTALLATIONSPECIFICATIONS GAS PRESSURE TESTINGINSTALLATION CHECKLIST INSTALLATIONMINIMUM FIREPLACE DIMENSIONS MANUFACTURED MOBILE HOME ADDITIONAL REQUIREMENTSGAS CONNECTION INSTALLATIONVENTING COMBUSTIBLE MANTELFLUE LINER INSTALLATION INSTALLATIONGAS PIPE PRESSURE TESTING GAS INSERT AERATION SYSTEMU32S-5using SIT 820 NOVA Gas Valve INSTALLATIONCONVERSION KIT # 434-969FROM NG TO LP IF IN DOUBT DO NOT DO THIS CONVERSIONInstaller Notice INSTALLATIONDo not overtighten the screw. Recommended to grip the wrench by the short sideInstallation of the DC Sparker INSTALLATIONIgnitor Wire Piezo Ignitor Ground wire from kitOPTIONAL REMOTE CONTROL INSTALLATIONto the 120V wires Thermostat Wire Table remote control the 120V wiresWIRING DIAGRAMS INSTALLATIONCAUTION Label all wires prior to disconnection when servicingINSTALLATION INSTALLATION ON BURNER INSTALLATIONGLASS CRYSTAL OR OPTIONAL CERAMIC STONES Minimum Air shutter OpeningDiagram Diagram 1a Diagram 1b Diagram INSTALLATIONSTANDARD FLUSH DOOR FACEPLATE AND DOOR FRAME INSTALLATION INSTALLATIONKit# 425-914Contents List Door FrameCompleted Faceplate & Door Frame Installation INSTALLATION8Lower the door frame gently into place 10Slide unit into final positionOPTIONAL HEARTH TRIM INSTALLATION INSTALLATION2 Hearth Trim Installation 4 Hearth Trim InstallationLIGHTING PROCEDURE OPERATING INSTRUCTIONSSHUTDOWN PROCEDURE OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS MAINTENANCE INSTRUCTIONSCOPY OF LIGHTING INSTRUCTION PLATE DO NOT REMOVE THIS INSTRUCTION PLATEGENERAL VENT MAINTENANCE MAINTENANCEDOOR GLASS GLASS GASKETFAN MAINTENANCE MAINTENANCEFAN REMOVAL BurnerFan access plate MAINTENANCEPilot assembly wires Base CoverREPLACING THE FAN MAINTENANCEVALVE ASSEMBLY REPLACEMENT MAINTENANCEON/OFF Wires Burner11Slightly lift out valve tray MAINTENANCE12 Disconnect the inlet gas line U32S-5FPI Direct Vent Gas InsertMAIN ASSEMBLY PARTS LISTDescription BURNER ASSEMBLY PARTS LISTDescription 4 10 11 9 131425-512Door Bottom Assembly 2425-513Frame Inside PARTS LISTFACEPLATE AND DOORFRAME 3425-514Faceplate Outside 4425-942Hearth TrimU32S-5FPI Direct Vent Gas Insert U32S-5FPI Direct Vent Gas Insert The Warranty Limited Lifetime WARRANTYConditions ExclusionsSee the inside back cover for details