Regency U32S-LP5, U32S-NG5 Installation, Gas Connection, Venting, Combustible Mantel, Clearances

INSTALLATION

COMBUSTIBLE MANTEL
	CLEARANCES
				G
	12	10	8	6	4	2	0
	18
47”	16			12" Mantel
						3-1/2"
(1194mm)	14
to ceiling						Mantel
	12
	10
		17"
	8
	6				13"
	4						Faceplate Top
	2
	0
			20“		Top of
		to floor
					Unit

GAS CONNECTION

GAS CONNECTION WARNING: Only persons licensed to work with gas piping may make the necessary gas connections to this appliance.

1)If the appliance is to be installed into an existing chimney system, thoroughly clean the masonry or factory built fireplace.

2)The appliance is provided with an opening on the left hand side of the control compartment. A3/8" NPT gas supply pipe must be brought near this inlet hole.

3)Locate the center point where the vent will pass through the chimney above the appliance. Move the appliance into the exact location where it is to be installed. Ensure that the Insert is level.

Alternate Approved Caps

46dva-VC	Vertical Termination Cap
46dva-VCH High Wind Cap
46dva-GK	3" Co-linear Adaptor with flashing

Side View

Due to the extreme heat this fireplace emits, the mantel clearances are critical.

Note: A non-combustible mantel may be installed at a lower height if the framing is made of metal studs covered with a non-combustible board.

Mantel can be installed anywhere in shaded area or higher using the above scale.

Note: Ensure the paint that is used on the mantel and the facing is "heat resistant" or the paint may discolour.

C

L

Gas

Inlet

VENTING

THE APPLIANCE MUST NOT BE

CONNECTED TO A

CHIMNEY FLUE SERVING A

SEPARATE SOLID FUEL

BURNING APPLIANCE.

This appliance is designed to be attached to two 3" (76mm) co-linear aluminium flex running the full length of the chimney. The flue length must be a minimum length of 8 ' (2.44m) and a maximum of 35' (10.7m). See chart below for minimum distances from roof. Periodically check that the vent is unrestricted.

Masonry chimneys may take various contours which the flexible liner will accommodate. However, keep the flexible liner as straight as possible, avoid unnecessary bending.

The Air Intake pipe must be attached to the inlet air collar of the termination cap.

Part #	Description
948-305	3" Flex - 35 ft.
946-529	Co-linear DV Vertical
	Termination Cap

In areas of consistently high winds, we recommend using the Simpson Dura-Vent System (46dva-GK adapter and 46dva-VCH high-wind cap).

The Air Intake pipe must be attached to the inlet air collar of the termination cap.

U32S-5 FPI Direct Vent Gas Insert 9