Regency U32S-NG5 Installation, Optional Wall Thermostat, Final Check, Optional Remote Control

Page 14
OPTIONAL WALL THERMOSTAT

INSTALLATION

OPTIONAL WALL THERMOSTAT

A wall thermostat may be installed if desired, follow the wiring diagram below. FPI offers an optional programmable thermostat but any 250- 750 millivolt rated non-anticipator type thermostat that is CSA, ULC or UL approved may be used.

CAUTION

Do not connect the millivolt wall thermostat wires

to the 120V wires.

Thermostat Wire Table

Recommended Maximum Lead Length

(Two-Wire) When Using Wall

Thermostat (CP-2 System)

Wire Size

Max. Length

 

 

 

14 GA.

50

Ft.

16 GA.

32

Ft.

18 GA.

20

Ft.

20 GA.

12

Ft.

22 GA.

9

Ft.

FINAL CHECK

Before leaving this unit with the customer, the installer must ensure that the appliance is firing correctly. This includes:

1)Clocking the appliance to ensure the correct firing rate (rate noted on label) at 15 minutes.

2)If required, adjusting the primary air to ensure that the flame does not carbon. First allow the unit to burn for 15 min. to stabilize.

3)Check for proper draft.

CAUTION

Any alteration to the product that causes sooting or carboning that results in damage to the exterior facia is not the responsibility of the manufacturer.

OPTIONAL REMOTE CONTROL

Use the FPI Remote Control Kit approved for this unit. Use of other systems may void your warranty.

The remote control kit comes with a hand held transmitter, a receiver and a wall mounting plate.

1)Choose a convenient location on the wall to install the receiver and the receptacle box (protection from extreme heat is very important). Run wires from the fireplace to that location. Use Thermostat Wire Table.

2)Connect the wires as per the wiring diagrams in this manual.

CAUTION

Do not connect the millivolt

remote control the 120V wires.

3)Install 3 AAA alkaline batteries in transmitter and 4 AA alkaline bat- teries in the receiver. Install the receiver and its cover in the wall. Switch the remote receiver to "remote" mode. The remote control is now ready for operation.

14

U32S-5 FPI Direct Vent Gas Insert

Image 14
Contents Owners Installation ManualU32 Sunrise Gas Insert 918-788TO THE NEW OWNER MAINTENANCE TABLE OF CONTENTSSAFETY LABEL PARTS LISTSAFETY LABEL for the State of Massachusetts only REQUIREMENTSMA Code - CO Detector 5.08 Modifications to NFPA-54,ChapterUNIT DIMENSIONS U32S-5FPI Direct Vent Gas InsertSPECIFICATIONS INSTALLATIONFOR YOUR SAFETY GAS PRESSURE TESTINGMINIMUM FIREPLACE DIMENSIONS INSTALLATIONINSTALLATION CHECKLIST MANUFACTURED MOBILE HOME ADDITIONAL REQUIREMENTSVENTING INSTALLATIONGAS CONNECTION COMBUSTIBLE MANTELGAS PIPE PRESSURE TESTING INSTALLATIONFLUE LINER INSTALLATION GAS INSERT AERATION SYSTEMCONVERSION KIT # 434-969FROM NG TO LP INSTALLATIONU32S-5using SIT 820 NOVA Gas Valve IF IN DOUBT DO NOT DO THIS CONVERSIONDo not overtighten the screw. Recommended to grip INSTALLATIONInstaller Notice the wrench by the short sideIgnitor Wire Piezo Ignitor INSTALLATIONInstallation of the DC Sparker Ground wire from kitto the 120V wires Thermostat Wire Table INSTALLATIONOPTIONAL REMOTE CONTROL remote control the 120V wiresCAUTION Label all wires prior INSTALLATIONWIRING DIAGRAMS to disconnection when servicingINSTALLATION GLASS CRYSTAL OR OPTIONAL CERAMIC STONES INSTALLATIONINSTALLATION ON BURNER Minimum Air shutter OpeningSTANDARD FLUSH DOOR INSTALLATIONDiagram Diagram 1a Diagram 1b Diagram Kit# 425-914Contents List INSTALLATIONFACEPLATE AND DOOR FRAME INSTALLATION Door Frame8Lower the door frame gently into place INSTALLATIONCompleted Faceplate & Door Frame Installation 10Slide unit into final position2 Hearth Trim Installation INSTALLATIONOPTIONAL HEARTH TRIM INSTALLATION 4 Hearth Trim InstallationSHUTDOWN PROCEDURE OPERATING INSTRUCTIONSLIGHTING PROCEDURE OPERATING INSTRUCTIONSCOPY OF LIGHTING INSTRUCTION PLATE MAINTENANCE INSTRUCTIONSOPERATING INSTRUCTIONS DO NOT REMOVE THIS INSTRUCTION PLATEDOOR GLASS MAINTENANCEGENERAL VENT MAINTENANCE GLASS GASKETFAN REMOVAL MAINTENANCEFAN MAINTENANCE BurnerPilot assembly wires MAINTENANCEFan access plate Base CoverMAINTENANCE REPLACING THE FANON/OFF Wires MAINTENANCEVALVE ASSEMBLY REPLACEMENT Burner12 Disconnect the inlet gas line MAINTENANCE11Slightly lift out valve tray U32S-5FPI Direct Vent Gas InsertDescription PARTS LISTMAIN ASSEMBLY Description PARTS LISTBURNER ASSEMBLY 4 10 11 9 13FACEPLATE AND DOORFRAME PARTS LIST1425-512Door Bottom Assembly 2425-513Frame Inside 3425-514Faceplate Outside 4425-942Hearth TrimU32S-5FPI Direct Vent Gas Insert U32S-5FPI Direct Vent Gas Insert Conditions WARRANTYThe Warranty Limited Lifetime ExclusionsSee the inside back cover for details