Regency U32S-LP5, U32S-NG5 Faceplate And Door Frame Installation, Kit# 425-914Contents List

Page 19
FACEPLATE AND DOOR FRAME INSTALLATION

INSTALLATION

FACEPLATE AND DOOR FRAME INSTALLATION

 

Kit# 425-914 Contents List:

1

Complete Faceplate with Switches

1

Door Frame

1Bottom Louver

2Hinges

2

Bottom Louver Brackets

4

Pan Head Screws

1

Wire Clip

1Instruction Sheet

1)Bring the faceplate up in front of the unit and connect the red & black ON/OFF wires from the unit to the ON/OFF switch on the back of the left side of the faceplate.

Note: Ensure that the flanges on the sides of the firebox are on the outside, when installing the faceplate (see below).

Faceplate

Flange on fi rebox Kit# 425-914 Contents List:

4)Fold down the 2 hinges on the bottom frame to a flat position. The bottom frame is installed with a friction fit - the opening in the corner of each hinge slides over the metal lip located on the floor of the unit.

2)Connect the grey coated female ends of the black & red fan wires from the unit to the male ends of the fan rheostat on the left side of the faceplate as shown.

Note: Ensure the bottom frame is positioned properly before installing, by making sure there is equal spacing on either side.

Openings on hinge

Metal Lip

Fan Rheostat

5) Push both bottom frame hinges down on the metal lip until they are fully seated.

3) Position faceplate on unit lining up screw holes on faceplate with screw holes on unit - secure with 4 screws.

6) Flip bottom louver up to close.

U32S-5 FPI Direct Vent Gas Insert

19

Image 19
Contents 918-788 Installation ManualU32 Sunrise Gas Insert OwnersTO THE NEW OWNER PARTS LIST TABLE OF CONTENTSSAFETY LABEL MAINTENANCESAFETY LABEL 5.08 Modifications to NFPA-54,Chapter REQUIREMENTSMA Code - CO Detector for the State of Massachusetts onlyU32S-5FPI Direct Vent Gas Insert UNIT DIMENSIONSGAS PRESSURE TESTING INSTALLATIONFOR YOUR SAFETY SPECIFICATIONSMANUFACTURED MOBILE HOME ADDITIONAL REQUIREMENTS INSTALLATIONINSTALLATION CHECKLIST MINIMUM FIREPLACE DIMENSIONSCOMBUSTIBLE MANTEL INSTALLATIONGAS CONNECTION VENTINGGAS INSERT AERATION SYSTEM INSTALLATIONFLUE LINER INSTALLATION GAS PIPE PRESSURE TESTINGIF IN DOUBT DO NOT DO THIS CONVERSION INSTALLATIONU32S-5using SIT 820 NOVA Gas Valve CONVERSION KIT # 434-969FROM NG TO LPthe wrench by the short side INSTALLATIONInstaller Notice Do not overtighten the screw. Recommended to gripGround wire from kit INSTALLATIONInstallation of the DC Sparker Ignitor Wire Piezo Ignitorremote control the 120V wires INSTALLATIONOPTIONAL REMOTE CONTROL to the 120V wires Thermostat Wire Tableto disconnection when servicing INSTALLATIONWIRING DIAGRAMS CAUTION Label all wires priorINSTALLATION Minimum Air shutter Opening INSTALLATIONINSTALLATION ON BURNER GLASS CRYSTAL OR OPTIONAL CERAMIC STONESDiagram Diagram 1a Diagram 1b Diagram INSTALLATIONSTANDARD FLUSH DOOR Door Frame INSTALLATIONFACEPLATE AND DOOR FRAME INSTALLATION Kit# 425-914Contents List10Slide unit into final position INSTALLATIONCompleted Faceplate & Door Frame Installation 8Lower the door frame gently into place4 Hearth Trim Installation INSTALLATIONOPTIONAL HEARTH TRIM INSTALLATION 2 Hearth Trim InstallationOPERATING INSTRUCTIONS OPERATING INSTRUCTIONSLIGHTING PROCEDURE SHUTDOWN PROCEDUREDO NOT REMOVE THIS INSTRUCTION PLATE MAINTENANCE INSTRUCTIONSOPERATING INSTRUCTIONS COPY OF LIGHTING INSTRUCTION PLATEGLASS GASKET MAINTENANCEGENERAL VENT MAINTENANCE DOOR GLASSBurner MAINTENANCEFAN MAINTENANCE FAN REMOVALBase Cover MAINTENANCEFan access plate Pilot assembly wiresREPLACING THE FAN MAINTENANCEBurner MAINTENANCEVALVE ASSEMBLY REPLACEMENT ON/OFF WiresU32S-5FPI Direct Vent Gas Insert MAINTENANCE11Slightly lift out valve tray 12 Disconnect the inlet gas lineMAIN ASSEMBLY PARTS LISTDescription 4 10 11 9 13 PARTS LISTBURNER ASSEMBLY Description3425-514Faceplate Outside 4425-942Hearth Trim PARTS LIST1425-512Door Bottom Assembly 2425-513Frame Inside FACEPLATE AND DOORFRAMEU32S-5FPI Direct Vent Gas Insert U32S-5FPI Direct Vent Gas Insert Exclusions WARRANTYThe Warranty Limited Lifetime ConditionsSee the inside back cover for details