INSTALLATION
INSTALLATION | UNIT DIMENSIONS |
CHECKLIST |
|
5) This appliance is Listed for bedroom instal- |
lations when used with a Listed Millivolt |
Thermostat. Some areas may have further |
requirements, check local codes before |
installation. |
1)Locate appliance
a)Room location, page 6
b)Clearances to Combustibles, page 6
c)Mantle Clearances, page 7
d)Framing & Finishing Requirements, page 8
e)Venting Requirements, pages 10 to 15.
2)Assemble Top Facing Support and Side Nailing Strips, page 8. (NOTE: must be done before installing unit into fireplace.)
3)Install vent, pages 10 to 19.
4)Make gas and electrical connections. Test the pilot. Must be as per diagram. Page 20. Convert to Propane if desired, page 21.
5)Install brick panels (optional), page 22.
6)Install logs and embers and rockwool where indicated on page 22.
7)Install Flush Door Front (Standard) and optional Flush Gold Trim, page 23.
8)Install optional Double Screen Door, page 24.
9)Install Optional Bay Front and optional Bay Gold Trim, page 24.
10)Install Louvers (Flush or Bay), pages 24 and 25.
11)Install optional Wall Switch, Remote Control, or Wall Thermostat, page 25.
11)Install Optional Fan, page 27.
13)Final check.
Before leaving this unit with the customer, the installer must ensure that the appliance is firing correctly and operation fully explained to customer.
This includes:
1)Clocking the appliance to ensure the cor- rect firing rate (rate noted on label) after burning appliance for 15 minutes.
2)If required, adjusting the primary air to ensure that the flame does not carbon. First allow the unit to burn for
CAUTION: Any alteration to the product that causes sooting or carboning that results in damage is not the responsibil- ity of the manufacturer.
LOCATING YOUR
GAS STOVE
1)When selecting a location for your stove, ensure that the clearances outlined on this page are met.
2)Provide adequate clearances for servicing.
3)The appliance must be installed on a flat, solid, continuous surface (e.g. wood, met- al, concrete). This may be the floor, or raised up on a platform to enhance its visual impact. If the appliance is going to be in- stalled on carpeting, combustible linoleum tile or other combustible material other than wood flooring, the appliance must be in- stalled on a metal or wood panel extending the full width and depth of the appliance.
4)The
6) | The |
| approved for alcove installations, which |
| meet the clearances listed on this page. |
7) | We recommend that you plan your installa- |
| tion on paper using exact measurements |
| for clearances and floor protection before |
| actually installing this appliance. Have a |
| qualified inspector, dealer, or installer re- |
| view your plans before installation. |
Note: For vent terminations see page 10.
Diagram 1
A)Flat on Wall
B)Flat on Wall Corner
C)Recessed into Wall/Alcove
D)Corner
DUCT SYSTEM
OPTION
KIT #946-556
The HeatWave Air Duct Kit increases the effectiveness of your fireplace by dispersing warm air from the fireplace to remote locations in the same room or other rooms in your home.
Up to two kits may be installed on the fireplace. Please Note: Only 1 HeatWave kit may be operated at one time. This includes the internal blower option as well.
6 | Regency |