INSTALLATION
OPTIONAL BRICK
PANELS
1)Undo the bottom 2 door latches and open and remove glass door. Remove logs.
2)Attach the 2 Rear Brick Retaining clips to the rear wall. Loosen the screws in the top and rear wall of the firebox and slide the retaining clips into position (tight against the firebox top) and then tighten the screws.
LOG SET INSTALLATION
Read the instructions below carefully and refer to the dia- grams. If logs are broken do not use the unit until they are replaced. Broken logs can in- terfere with the pilot operation.
The "02" refer
numbers (i.e.
Note: The logs must not be in the unit.
3)Insert the back brick panel by carefully slipping it between the back wall of the firebox and the rear log bracket.
4) Put the side panels in next. Slide them in from |
the front and push them flat up against the |
wall. Be very careful not to scratch them on |
the firebox hardware. |
The gas log kit (Part #
A) | Rear Log | ||
B) | Middle Cross Log | ||
C) | Front Left Cross Log | ||
D) | Rear Left Log | ||
E) | Front Right Cross Log | ||
F) |
| Embers | |
G) |
| Vermiculite |
NOTE: If you will be installing the optional Brick Panels, install the Brick Pan- els prior to installing the logs.
1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.
2)Sprinkle the vermiculite around the firebox base.
4)Place Log B)
Notch
B)
BracketBracket
A) 02-57
B) 02-61
5)Slide the Top Brick Panel into position and slide the Top Brick Retaining clips so that they hold the Top Brick Panel in place and tighten down the screws.
5) Position Log C)
Vermiculite | Vermiculite | Vermiculite | grate tab. |
|
|
| Cutouts |
3)Place the Log A)
C)
A)
A)
B)
2nd Grate Tab
22 | Regency |