INSTALLATION
BACK-UP BATTERY INSTALLATION
1)Unsecure the battery from the outer fi rebox base fl ange by cutting the cable tie and remove from protective wrapping.
2)Remove the plastic pin protectors from the battery.
3)Loosen the screw that holds the right side heat shield in place.
Heat
Shield
4)Lift the heat shield up and pull out slightly to clear the head screws and then hang it on the top bracket (located directly above the heat shield, close to the top of the fi rebox).
5)Pull out the battery wires from the right side of the fi rebox.
Battery
Wires
6)Connect the red and black wires to the battery accordingly.
7)Place the battery into position on the velcro at the base of the fi rebox as shown.
8)
INSTALLATION
Regency® L900E Direct Vent Gas Fireplace | 27 |