Regency L900E-NG Brick Panel Installation, Handle with care. do not Force Into Position

Page 28

INSTALLATION

BRICK PANEL INSTALLATION

IMPORTANT: Must install 1 set of brick panels. The operation of this unit without the brick panels is prohibited.

Dangerous operating conditions may occur if the panels are broken.

Handle with care. DO NOT FORCE INTO POSITION.

INSTALLATION

Interior Brick Panel Installation:

1)Remove the glass door.

a.Release the 2 door latches on the left and right side at the top of the firebox.

Latch Location

Latch

3)Remove the 2 brick panel clips on the inside left and right side of the firebox by removing the screw.

Brick

Panel

Clip

Screw

4)Place the 2 small back brick panels at the base of the firebox on the left and right side of the rear log tray.

b. Swing the door out from the top and release the hinges on the left

Note: The left and right side back brick panels are different.

 

 

and right side of the door by lifting them up.

 

 

 

Left Side Back

Right Side Back

 

Brick Panel

Brick Panel

Hinge

 

 

Door

 

 

c. Place the door on a soft surface to prevent scratching.

2)Unwrap the brick panels from the protective wrapping.

Note: The logs must not be in the unit.

Left Side

Right Side

 

Back Brick

 

Back Brick

 

Panel

 

Panel

 

 

28

Regency® L900E Direct Vent Gas Fireplace

Image 28
Contents Libertytm L900E Gas Fireplace Manufactured Mobile Home Requirements Information for MOBILE/MANUFACTURED Homes After First SaleTable of Contents Safety Label InstallationRequirements MA Code CO DetectorUnit Dimensions Installation General Safety InformationInstallation Checklist Important Message Save These InstructionsHeat Release KIT Hearth RequirementsManufactured Mobile Home Additional Requirements Locating Your GAS FireplaceClearances Mantel Clearances Mantel LEG ClearancesFraming & Finishing Header On EdgeUnit Assembly Prior to InstallationVenting Introduction Vent Restrictor PositionExterior Vent Termination Requirements Horizontal Termination Flex Venting ArrangementsFPI Kit # Length Contains Rigid Pipe Venting Systems Basic Horizontal & Vertical Terminations8 Rigid Pipe Cross Reference Chart 58DVA-16ABL676 & L900 Direct Vent Fireplace Vent Restrictor Setting Allowable Horizontal TerminationsHorizontal Venting with Two 2 90o Elbows Vertical Venting with Three 3 90o Elbows Allowable Vertical Terminations Unit Installation with Horizontal Termination Unit Installation With Vertical Termination DiagramMinimum Vent FeetUnit Installation Astrocap XLPilot Adjustment TestingAeration GAS Line Installation AdjustmentBACK-UP Battery Installation Heat ShieldBrick Panel Installation Handle with care. do not Force Into PositionExterior Brick Panel Installation LOG SET Installation 03-41 03-44 03-45 03-4203-43Embers on bottom brick panel Wiring Diagram Do not cut the ground terminal off under any circumstancesOperating Instructions Backup Battery Operation During Power OutageNormal Operating Sounds GAS Appliances For Your Safety Read Before Lighting Copy of Lighting Plate InstructionsMaintenance Control BOX Replacement BACK-UP Battery ReplacementMaintainence Do not Remove Valve Tray Replacement Latch ScrewRear Log Stand Parts List Main AssemblyBurner & LOG Assembly Description 910-937Warranty Warranty Limited LifetimeInstaller Please complete the following information