Danby DPAC9030 Window / Patio Door Kit Installation, Plug the unit into a 115 V / 60 Hz grounded

Window / Patio Door Kit Installation

Your window kit has been designed to fit most standard “vertical” / “horizontal” windows and patio doors. Patio door applications upto a maximum height of 80”. Please refer to Fig. 2, Fig. 2a, & Fig. 2b for minimum and maximum openings. For vertical window and/or patio door applications, multi- lock positions are provided on the edge of each slider section. Two lock screws are provided to secure each sliding section together. Fig. 2c.

Horizontal Window
Window Slider Kit			Fig. 2
Minimum: 26	5	/8" (67.5 cm)
Maximum: 48 3/8" (123 cm)

1)Select a suitable location,making sure you have access to an electrical outlet.

2)Install both flexible hoses to the rear side of the unit. Both hoses are identical and can be installed into either opening. Insert the hose adapter with the 3 (L shaped) lock tabs into the 3 slots on the top of each opening and twist to lock into position.

4)	Install the adjustable Window/Patio Door Slider
Kit as required. Fig’s. 2, 2a, 2b. NOTE:
5)	Install the window exhaust adapters into the
openings in the slider section, making sure the
window slider section are secure.

Vertical

Window

Fig. 2a

Window Slider Kit Minimum: 26 5/8" (67.5 cm) Maximum: 48 3/8" (123 cm)

6) Plug the unit into a 115 V / 60 Hz grounded

electrical outlet.

NOTE: Steps # 2, 3, 4, 5 are only required when operating the unit during air conditioning mode.

Please Note: In a vertical application, the exhaust hose is to go above the intake hose in the window slider. This will avoid having the exhaust heat go through the intake and back into the unit.

DO NOT USE A REGULAR EXTENSION CORD. If it is necessary to use an extension cord with this unit, use an approved “air conditioner” extension cord only. (available at most local hardware stores)

Patio
Door
	Fig. 2c
Patio Door Kit
Minimum:	26 5/8" (67.5 cm)
Maximum: 80" (203 cm)
Fig. 2b

7