Integra DTR-7.4 instruction manual Connecting Antenna, Connecting the AM Loop Antenna

Connecting Antenna

This chapter explains how to connect the supplied indoor FM antenna and AM loop antenna, and how to connect commercially available outdoor FM and AM antennas.

Connecting the AM Loop Antenna

The supplied indoor AM loop antenna is for indoor use only.

DIGITAL		PRE OUT		ANTENNA
IN		R	L
COAX	FRONT
	SUB		CENTER		AM
2
	SURR
3
	SURR	R	L
OPT	BACK/
1	ZONE 2				FM
					75
2	FRONT		MULTI CH
	R		INPUT	AUDIO
			L	R	L
	SUB		CENTER
3					PHONO
					IN
	SURR
DIGITAL					CD
OUT		R	L		IN
OPT
1
	SURR
	BACK				TAPE
2
	GND				IN
				R	L

AUDIO

AM antenna push terminals FM antenna connector

AUDIO	VIDEO	S VIDEO	COMPONENT	FRONT SPEAKERS		SURR SPEAKERS
			VIDEO
		MONITOR	OUTPUT	R	L	R	L	AV RECEIVER
		OUT	Y					MODEL NO. DTR-7.4
R	L							RATING: AC 120V 60 Hz 8.1A

OUT	ZONE 2	P
					AC OUTLETS
IN	DVD	P
		INPUT 1
OUT		Y	ETHERNET
	VIDEO 1		(Net -Tune)	SURR
IN		P	CENTER	BACK/
			SPEAKER	ZONE 2
				SPEAKERS	AC 120V	60 Hz
					SWITCHED
					TOTAL 120W 1A MAX.

OUT		P
	VIDEO 2			R		L
		INPUT 2
IN		Y	I R			AC INLET
				A	ZONE 2
			IN		12V
					TRIGGER OUT
IN	VIDEO 3	P	RS232
IN	VIDEO 4	P
				B

R L

AUDIO VIDEO S VIDEO

1 Assemble the AM loop antenna, inserting the tabs into the base, as shown.

Connecting the Indoor FM Antenna

The supplied indoor FM antenna is for indoor use only.

1 Attach the FM antenna, as shown.

■USA and Canadian Model

FM

75 Insert the plug fully

into the socket.

■Australian Models

FM

75	Insert the plug fully
	into the socket

Once your DTR-7.4 is ready for use, you’ll need to tune into an FM radio station and adjust the position of the FM antenna to achieve the best possible reception.

2 Use thumbtacks or something similar to fix the FM antenna into position.

Thumbtacks, etc.

Caution: Be careful that you don’t injure your- self when using thumbtacks.

If you cannot achieve good reception with the supplied indoor FM antenna, try using a commercially available outdoor FM antenna instead (See page 15).

2 Connect both wires of the AM loop antenna to the AM push terminals, as shown.

(The antenna’s wires are not polarity sensitive, so they can be connected in either terminal.)

Make sure that the wires are attached securely and that the push terminals are gripping the bare wires, not the insulation.

Push	Insert wire	Release
		AM

Once your DTR-7.4 is ready for use, you’ll need to tune into an AM radio station and adjust the position of the AM antenna to achieve the best possible reception. Keep the antenna as far away as possible from your DTR-7.4, TV, speaker cables, and power cords.

If you cannot achieve good reception with the supplied indoor AM loop antenna, try using a commercially available outdoor AM antenna (See page 15).

14