Integra DTR-7.4 instruction manual Connecting the Power Cords from Other Devices

Connecting to Audio/Video Equipment—Continued

Connecting a Cassette Tape Deck, MD Recorder, DAT Deck, or CD Recorder (TAPE)

DIGITAL

PRE OUT

ANTENNA

AUDIO

VIDEO S VIDEO

COMPONENT

IN

R

L

VIDEO

COAX

FRONT

MONITOR

OUTPUT

1

OUT

Y

R

L

2

SUB

CENTER

AM

OUT

ZONE 2

P

DIGITAL

SURR

3

SURR

IN

DVD

P

IN

OPT

BACK/

R

L

INPUT 1

ZONE 2

75

OUT

1

OUTY

OPT

FM

2

FRONT

MULTI CH

IN

VIDEO 1

P

R

INPUT

AUDIO

2

3

L

R

L

PHONO

OUT

P

TAPE

SUB

CENTER

IN

VIDEO 2

SURR

INPUT 2

DIGITAL

CD

IN

Y

OUT

R

L

IN

DIGITAL

OPT

OUT

IN

1

SURR

IN

VIDEO 3

P

OUT

BACK

TAPE

L

2

IN

VIDEO 4

P

OPT

IN

R

GND

R

L

R

L

VIDEO AUDIOS VI EO

AUDIO

AUDIO

1

DIGITAL

OUT

OPT	DIGITAL	R	L	R	L
	IN	AUDIO OUT		AUDIO IN

OPT

MD recorder, DAT deck,	Cassette tape deck, MD recorder,
or CD recorder	DAT deck, or CD recorder

Using RCA audio connection cables, connect the output jacks (PLAY) of the device to the TAPE AUDIO IN jacks of the DTR-7.4 and connect the input jacks (REC) of the device to the TAPE AUDIO OUT jacks of the DTR-7.4. Make sure that you properly connect the left channels to the L jacks and the right channels to the R jacks.

If the device has a digital output, connect it to either the DIGITAL IN COAX jack or DIGITAL IN OPT jack of the DTR-7.4, depending on the type of connector on the device.

On the initial settings of the DTR-7.4, the TAPE input source is set for digital input at the OPT 2 jack.

If the digital connection is made to a different jack, this must be changed at Setup Menu → Input Setup → Digital Setup (See page 36).

If the device has a digital input, connect it to the DIGITAL OUT OPT jack of the DTR-7.4 for digital recording of the REC OUT signal from the DTR-7.4. However, if the same device also has a digital output and it has already been connected to the DTR-7.4, you cannot connect the digital input of the device to the DIGITAL OUT jack of the DTR-7.4 simultaneously.

Note:

The output from the DIGITAL OUT jack of the DTR-7.4 is only the digital signal input to the DIGITAL IN jack.

Connecting the Power Cords from Other Devices

The DTR-7.4 is equipped with AC mains outlets for connecting the power cords from other devices so that their power is supplied through the DTR-7.4. By doing this, you can leave the connected device turned on and have the Standby/On button on the DTR-7.4 turn on and off the device together with the DTR-7.4.

The shape, number, and total capacity of the AC outlets may differ depending on the area of purchase. Caution:

Make sure that the total capacity of the components connected to the DTR-7.4 does not exceed the capacity that is printed on the rear panel (e.g., TOTAL 120W).

	AC OUTLETS	AC OUTLET
	AC 120V 60 Hz	AC 230-240V 50 Hz
		SWITCHED 100W MAX.
	SWITCHED
TOTAL 120W 1A MAX.

USA and Canadian models Australian model

24