Integra DTR-7.4 Using the Remote Controller with Other Components, Entering a Remote Control Code

Using the Remote Controller with Other Components

You can use the DTR-7.4’s remote controller (RC- 550M) to control your other AV components, including those made by other manufacturers. To do this you can:

•Enter a remote control code for the component that you want to control (e.g., DVD, TV, VCR).

•Learn commands directly from the other component’s remote controller (see page 94).

•Use the Macro function to learn a sequence of actions (see page 95).

•You can also edit the remote controller modes (see page 97).

Entering a Remote Control Code

By entering the appropriate remote control code for each of your components, you can control each compo- nent by selecting the relevant remote controller mode: DVD, TV, VCR, CBL (cable), or SAT (satellite).

1	Look up the appropriate remote
	control code for the component.
	See “Remote Control Codes” on page
	90-91.
2	Press and hold down the Custom
Custom	button for more than three sec-
	onds.
	The remote controller enters Custom
	mode.
3	Roll the scroll wheel to select
	“PRGRM,” and then press the
	scroll wheel.

4	Roll the scroll wheel to select the
	the remote controller mode you
	want to use with the component,
	and then press the scroll wheel.
	The following remote controller modes
	can be selected: DVD, TV, VCR, CBL,
	or SAT.

5	Use the number buttons to enter
	the 4-digit remote control code.

If the code is accepted, the following

appears on the display for a while, and then the normal display reappears.

If the code is not accepted, after the message “RETRY” has been displayed, the code entry display reappears, and you should try entering the code again. To cancel this procedure at any point, press the Custom button.

6	Select the remote controller mode,
	point the remote controller at the
	component, and check its opera-
	tion.
	The remote controller buttons that can
	be used in DVD mode are shown on
	page 84. Those that can be used with the
	TV, VCR, CBL, and SAT modes are
	listed on pages 92 and 93.

Remote Control Codes for an Onkyo DVD player

The remote control code that you use with an Onkyo DVD player depends on whether it’s connected via , as follows:

5001: Use this code if you’ve connected an cable and an RCA/phono analog audio connection cable to your DVD player. This is the default setting, so if you’re using , you don’t need to change it. Point the remote controller at the DTR-7.4 to operate the DVD player.

5002: Use this code if your DVD player doesn’t have

an socket, or you’re not using . Point the remote controller at the DVD player to operate it.

Remote Controller

89