Integra DTR-7.4 instruction manual Input Setup Basic

Input Setup (Basic)—Continued

2-4.Character Input

Input:DVD

a.Character Display :No

b.Character

:

Press to edit. to clear.

Quit:[SETUP]

8		After you have completed the
		name, press the Enter button until
		you return to the Character Input
	Enter	Sub-menu.

Once 10 characters are entered, you will automatically return to the previous screen. If the name is completed before you enter 10 characters, enter spaces until 10 characters are entered.

7

Enter

Enter

Use the / / / buttons to move the cursor to the desired character and then press the Enter button.

The characters entered will appear in order in the 10-character space field above.

2-4.Character Input

Input:DVD

b.Character

:

ABCDEFGHIJKLM

NOPQRSTUVWXYZ

abcdefghijklm nopqrstuvwxyz [ENTER] 0123456789-.’

()+*/=,:;!?_

Back:

[RETURN]

Note:

If you are using the front display and not the OSD Menu, press the button when “Char: ” appears in the front display.

Then “ABCDEF..” appears. This is the Character Input screen. The cursor but- tons will allow you to navigate through this screen just as they would if you were using the OSD Menu so you will need to refer to the figure below for the actual layout of the Character Input screen. At the Character Input screen, press the cursor buttons to move the cursor to the desired character and then press the Enter button. The characters entered will appear in order in the 10-character space field above. After two seconds, the Char- acter Input screen appears again.

To change an existing character,

move the cursor backward with the Return button or forward with the Enter button to the location of the mistaken character and then enter the desired char- acter as explained above.

To erase a character,

enter a blank space in its place.

Adjusting the Volume Differences Between Components (IntelliVolume)

This sub-menu allows you to adjust for the volume dif- ferences between your various input source components. When switching input sources, you may find that the output level for different components or input sources connected to the DTR-7.4 is different even though the main volume setting is the same. Under normal circum- stances, you would then have to change the volume set- ting each time you change the input source. This Intelli Volume setting allows you to preset a volume level for each input source separately so that when you do switch from one input source to another, the DTR-7.4 adjusts the volume accordingly and the volume stays the same.

1-3	Use the same procedures as the
	ones for the “Character Input”
	sub-menu to display the “Input
	Setup” sub-menu.
4	Use the and cursor buttons to
	select “IntelliVolume” and then
	press the Enter button.
Enter	The “IntelliVolume” menu appears.
	2-5.IntelliVolume Setup
	Input:DVD
	a.IntelliVolume
	: 0dB

Enter

Quit:[SETUP]

5 Use the and cursor buttons

to set the desired value.

If the volume is quieter than other

Enter sources, increase its decibel level with

the cursor button, or if it is louder than other sources, decrease its decibel level with the cursor button.

The Intelli Volume can be adjusted between –12 and +12 decibels.

6	Press the Setup button to return to
	the main menu.

Useful Settings (Basic)

53