Integra DTR-7.4 Speaker Setup, Changing the Remote Controller’s Control ID, TV Format Sub-menu

Selecting the Appropriate Setting for Your Connections—Continued

Changing the Remote Controller’s Control ID

This section explains how to change the remote control- ler’s ID. You may need to change this if the DTR-7.4’s remote controller interferes with other Integra/Onkyo components located in the same room.

Note:

If you change the remote controller’s ID, be sure to select the same ID on the DTR-7.4. For details on setting up the DTR-7.4’s remote control ID, refer to the previous “Remote Setup Sub-menu” section. The default ID for both the DTR-7.4 and remote controller is 1.

1	Hold down the remote controller’s
Custom	Custom button for more than three
	seconds.
	The remote controller enters Custom
2	mode.
	Roll the scroll wheel to select
	“SETUP” menu, and then press
	the scroll wheel.

3	Roll the scroll wheel to select ID
	menu, and then press the scroll
	wheel.

Speaker Setup

After you have installed the DTR-7.4, connected all the components, and determined the speaker layout, it is now time to perform the settings in the Speaker Setup Menu to optimize the sound acoustics for your environment and speaker layout.

Before you perform the following settings, it is important that you first determine the following items:

•The types and sizes of the speakers that are connected.

•The distance from each speaker to the normal listening position.

			Monitor
Front		SW Center			Front
Left					Right
	[	]	[	]m/ft
		m/ft
[	]m/ft			[	]m/ft
SL					SR
[		]m/ft		[	]m/ft
[	]m/ft			[	]m/ft
		SBL		SBR

4	Roll the scroll wheel to select an
	ID—1 (default), 2, or 3—and then
	press the scroll wheel.
	Select the same ID as that set on the
	DTR-7.4.

Basic Menu

0.Hardware Setup 1.Speaker Setup 2.Input Setup 3.Audio Adjust

→Advanced Menu

[ENTER]Quit:[SETUP]

1.Speaker Setup

1.Speaker Config 2.Speaker Distance 3.Level Calibration

[ENTER]Quit:[SETUP]

TV Format Sub-menu

a. TV Format (Australian model only)

When you want to reconfigure the settings conforming to the television format used for the area where you use the DTR-7.4, use this sub-menu so that no time is wasted on detection.

Auto: This is the default setting. When you leave this setting unchanged, the television format is detected and automatically set by the DTR-7.4. PAL: Use this setting when you know that the televi- sion format is PAL.

NTSC: Use this setting when you know that the tele- vision format is NTSC.

0-4.TV Format

a.TV Format

:Auto

Quit:[SETUP]

If you want to perform these operations using the remote controller, first press the scroll wheel.

1 Display the main menu.

Press the Setup button on the front panel, or press the scroll wheel and then press the Setup button on the remote controller to display the main menu on the monitor and front display.

2	Use the	and	cursor buttons to select
	“1. Speaker Setup” and then press the
	Enter button.
	The “Speaker Setup” menu appears.
3	Use the	and	cursor buttons to select
	an item and then press the Enter button.
4	Use the	and	cursor buttons to select
	an item and then use the and cursor
	buttons to set the desired value.
5	Press the Setup button to exit the Setup
	menu.

Press the Return button to return to the previous menu.

32