Integra Connecting an equalizer DTR-7, Connecting the power, Connecting a power cable

Connecting an equalizer (DTR-7)

DTR-7

DIGITAL INPUT	R	L	R	L	V	S	SURROUND SPEAKERS	FRONT SPEAKERS A
	AMP IN

	FRONT					OUT
COAXIAL					VIDEO-1	ANTENNA
1	PRE OUT
							R	L	R	L
	FRONT					IN
COAXIAL						AM
2	SUB
OPTICAL	WOOFER					OUT			CENTER
1	CENTER				VIDEO-2				SPEAKER
						IN			CAUTION: SPEAKER IMPEDANCE
OPTICAL	SURROUND					FM	R	L	6 OHMS MIN. / SPEAKER
2						75
	FRONT				VIDEO-3	IN
OPTICAL
	SUB				DVD				AC OUTLETS
	WOOFER					IN	FRONT SPEAKERS B		AC 120V 60Hz
DIGITAL OUTPUT
						AV RECEIVER			SWITCHED
	CENTER								TOTAL 120W 1A MAX.
	SURROUND			(REC)	MONITOR	MODEL NO. DTR-7
	MULTI CHANNEL
	INPUT			OUT	OUT
	R		L	TAPE	�					AC INLET
					SOURCE
	CD			IN	MULTIOUT
				(PLAY)
	GND				VIDEO
	PHONO				S VIDEO
	R	L	R	L	OSD SELECTOR
						LOCAL REMOTE	REMOTE
							CONTROL
			R		L
AMP IN							Output jack
	FRONT
PRE OUT							Input jack
	FRONT

Input jack

Epualizer

The AMP IN and the PRE OUT FRONT connectors are attached with jumper plugs. When connecting an equalizer, remove these jumper plugs before connecting the audio connection cables.

1. Remove the jumper plugs.

See “Connecting power amplifiers.”

2. Connect an equalizer.

Connecting the power

DIGITAL INPUT	R	L	R	L	V	S	SURROUND SPEAKERS	FRONT SPEAKERS A
	AMP IN

	FRONT						OUT
COAXIAL						VIDEO-1	ANTENNA
1	PRE OUT							R	L	R	L
	FRONT						IN
COAXIAL
2	SUB
OPTICAL	WOOFER						OUT			CENTER
1	CENTER					VIDEO-2				SPEAKER
							IN			CAUTION: SPEAKER IMPEDANCE
OPTICAL	SURROUND							R	L	6 OHMS MIN. / SPEAKER
2
	FRONT					VIDEO-3	IN
OPTICAL
	SUB					DVD		FRONT SPEAKERS B		AC OUTLETS
	WOOFER									AC 120V 60Hz
DIGITAL OUTPUT							IN			SWITCHED
	CENTER						AV RECEIVER			TOTAL 120W 1A MAX.
	SURROUND				(REC)	MONITOR	MODEL NO. DTR-7
	MULTI CHANNEL
	INPUT				OUT	OUT
	R		L		TAPE	�
	CD				IN
					(PLAY)
	GND					VIDEO
	PHONO					S VIDEO
	R	L	R	L		OSD SELECTOR
							LOCAL REMOTE	REMOTE
								CONTROL

AC INLET

1

2

Connecting a power cable

1.Connect the outlet plug on the included power cable to the AC INLET on the DTR-7/ DTR-6.

2.Plug-in the other end of the cable to a wall AC outlet.

Notes:

•Do not use any power cable other than the included cable. The included cable is designed for use only with the DTR-7/ DTR-6. Do not use it for any other device.

•Do not connect or disconnect the outlet plug from the DTR-7/DTR-6 while the other end is plugged into the wall AC outlet.

2.STANDBY/ON button STANDBY indicator

1POWER switch Display

FM MUTE/

CHARACTER/

SP/SYS

AUDIO

BASS/

MASTER VOLUME

DIMMER

MODE

DOWN

TUNING

UP

MEMORY

SETUP

ADJUSTMENT

TREBLE

STANDBY/ON

MODE

W

N

D O

U

PRESET/MODE ADJ

P

STANDBY MULTI SOURCE

POWER

ON OFF

PUSH TO ENTER

A SPEAKERS B

LISTENING MODE

REC OUT/

DIGITAL/

DISPLAY

DIRECT

STEREO

/DTS

THX

DSP

MULTI SOURCE

ANALOG

CH LEVEL

SURROUND

MODE

PHONES

MULTI CH INPUT

VIDEO4 (MONO)

DVD

VIDEO-1

VIDEO-2

VIDEO-3

VIDEO-4

TAPE

FM

AM

PHONO

C D

S VIDEO

VIDEO

L AUDIO R

DTR-7 by

2.POWER STNBY button

2.POWER ON button

1.MODE AUDIO button

Connecting the power

•Before you turn on the receiver, confirm that all connections have been made properly.

•Turning on this receiver’s power may cause a momentary power surge, which might interfere with other electrical equipment, such as computers. If this happens, use a wall outlet on a differ- ent circuit.

1.Press the POWER switch to set the receiver to Standby mode.

The STANDBY indicator will light up.

2.Press the STANDBY/ON button to turn on the receiver. The display will light up and the STANDBY indicator will be turned off.

If you press the STANDBY/ON button, the receiver returns to Standby mode.

Turning the power on from the remote controller:

1.Press the MODE AUDIO button.

2.Press the POWER ON button to turn on the power to the receiver, or press the POWER STNBY button to set the re- ceiver in standby mode.

•You cannot use the remote controller if the POWER switch on the receiver is set to OFF.

•Set the volume level to minimum before you turn off the power to the receiver.

13