Integra DTR-7 instruction manual Setting the speaker configuration, Front, Center Surround

Setting the speaker configuration

Perform this setup before using the unit.

SP/SYS SETUP button SMART SCAN CONTROLLER

	FM MUTE/			CHARACTER/	SP/SYS	AUDIO	BASS/
DIMMER	MODE	DOWN TUNING	UP	MEMORY	SETUP	ADJUSTMENT	TREBLE

STANDBY/ON

MODE

PRESET/MODE ADJ

STANDBY MULTI SOURCE						SMART SCAN
STAND-BY						CONTROLLER
POWER
							PUSH TO ENTER
ON OFF
				LISTENING MODE			REC OUT/	DIGITAL/
A SPEAKERS B
	DISPLAY	DIRECT	STEREO	/DTS	THX	DSP	MULTIRECSOURCET	ANALOG	CH LEVEL
				SURROUND			MODE

MASTER VOLUME

		W	N
D	O

U

P

PHONES

MULTI CH INPUT

VIDEO4 (MONO)

DVD

VIDEO-1

VIDEO-2

VIDEO-3

VIDEO-4

TAPE

FM

AM

PHONO

C D

S VIDEO

VIDEO

L AUDIO R

DTR-7 by

1	SP/SYS				Setting the speaker configuration parameters
	SETUP		SPEAKERS	TUNED
			A	AUTO	Using the SMART SCAN CONTROLLER, you can easily set the
					speaker configuration. Turn it to select the parameter and press it to
					go to the next item.
					1. Press the SP/SYS SETUP button.
	PRESET/MODE ADJ				“Config Setup?” appears. Then Press the SMART SCAN CON-
					TROLLER.
					2. For the DTR-6, go to the next step.
					For the DTR-7, “All Ch For THX” appears.
	PUSH TO ENTER				Set “Yes” or “No.”
					Yes:	Your system is a THX speaker system.
2						(The following steps are unnecessary.)
	PRESET/MODE ADJ	DTR-7 only			No : Your system is a non-THX speaker system.
					Press the SMART SCAN CONTROLLER.
			SPEAKERS	TUNED	3. Set whether or not a subwoofer is connected.
			A	AUTO
					Yes:	A subwoofer is connected.
					No:	A subwoofer is NOT connected.
	PUSH TO ENTER				Press the SMART SCAN CONTROLLER.
					4. Select the size of your front speakers.
	PRESET/MODE ADJ				Large: Large front speakers are used.
					Small: Small front speakers are used.
					Press the SMART SCAN CONTROLLER.
					5. Select the size of your center speaker.
					Large: A large center speaker is used.
	PUSH TO ENTER				Small: A small center speaker is used.
					None: A center speaker is NOT used.
3 ~ 6
					Press the SMART SCAN CONTROLLER.
					6. Select the size of your surround speakers.
	PRESET/MODE ADJ
					Large: Large surround speakers are used.
			A	FM STEREO AUTO	Small: Small surround speakers are used.
			SPEAKERS	TUNED
					None: Surround speakers are NOT used.
					7. Press the SMART SCAN CONTROLLER.
	PUSH TO ENTER				This completes the speaker configuration setup.

Front

PRESET/MODE ADJ

Center

Surround

PUSH TO ENTER

7 PRESET/MODE ADJ

PUSH TO ENTER

18