Windsor 10080480 operating instructions OPERATIONS-USING the Hand Tool

Page 20

OPERATIONS-USING THE HAND TOOL

HAND TOOL

CONNECTION

SOLUTION QUICK

DISCONNECT

STEP 1

Use only acceptable accessory tools. See Optional Accessories section.

To connect solution hose pull back collar and insert over machine mounted fitting, then release collar to lock into place. Solution connection can remain connected at all times.

Disconnect vacuum hose and connect the hand tool to hand tool connection as shown.

HAND TOOL POSITION

STEP 2

Select hand tool switch.

STEP 3

Squeeze handle on accessory tool to begin cleaning.

3-12	86302100 CLIPPER DUO 10/02/07

Image 20

Contents Carpet Extractor Machine Data LOG/OVERVIEW Table of Contents HOW to USE this Manual Important Safety Instructions SafetyHazard Intensity Level Do not Operate MachineVolt Models Safety Label Location Technical Specifications OperationsOperations Special Notes MeasureHOW this Machine Works OPERATIONS-COMPONENTS OPERATIONS-COMPONENTS OPERATIONS-FILLING the Solution Tank Dry spills from top of solution tankOPERATIONS-PRE RUN Setup OPERATIONS-PRE RUN Setup OPERATIONS-OPERATING the Machine Shut Recovery OPERATIONS-USING the Hand Tool MAINTENANCE-SERVICE Schedule Service ScheduleMAINTENANCE-COMPONENTS MAINTENANCE-PERIODIC Periodic MaintenanceMAINTENANCE-CIRCUIT Protection Circuit BreakersMAINTENANCE-SCRUB Deck Scrub Head MAINTENANCE-VACUUM Motor Vacuum Motor Carbon Brushes ReplacementMAINTENANCE-TROUBLESHOOTING Problem Cause SolutionParts List Brush Deck HOUSING, Brush Drive HOUSING, Brush ClipPRV no QTY Description Serial no From SCR, M4X8, SET, ISO4029,CP,BLKBrush Deck Motor Brush Deck Motor Brush Deck Mounting Brush Deck Mounting Control Panel BOOT, 3/8 Circuit Breaker SWITCH, Dpdt 2-POSITION RockerSWITCH, DPDT3-POSITION Rocker SWITCH, Spst 2- Position RockerDecal LABEL, Accessory LABEL, Brush InstallPRV no QTY Description LABEL, Clipper DUOHand Tool RETAINER, Solution Hose Hand ToolNIPPLE, 1/8 FPT QD FEM Brass HOSE, 1/4 RetractableHandle Handle Handle Bracket BRKT, Handle Pivot PLATE, Handle Pivot LatchLEVER, Handle Release Left LEVER, Handle Release RightHandle Mounting PANEL, CONN. Access CAP, HANDLE, OuterCAP, HANDLE, Inner BRUSH, Handle CAPHandle Release Lever Handle Release Lever Recovery Tank HOOK, WIREFORM, Handtool DOME, 2 HoseGASKET, Dome Float SHUT-OFFSolution Solution 26 29 30 27 HARNESS, Handle Connector LABEL, Ground SymbolCLAMP, 1/4 ID Hose HOSE, 1/4 ID Nylobrd XSolution Tank COVER, CLP Solution NIPPLE, 1/8FPT QD ,MALE BrassHose ASM, FCT Adptr X 60 Nbrd CLAMP, 1.0 Worm GearVAC Shoe VAC Shoe VAC Shoe Mounting VAC Shoe Mounting Vacuum SCR, #8 X 2 Pphsms COVER, VAC MotorASSY, VAC Motor CLAMP, 1.75 Worm GearWheel & Axle Wheel & Axle HUBCAP, 9.75 WheelHUBCAP, 5/8 Shaft Axle ASM, Clipper DUOWiring Diagram Wiring Diagram Brush Deck Wiring HarnessHARNESS, Handle HARNESS, Brush DeckSuggested Spare Parts Serial Numbers Model Serial #