MAINTENANCE-SCRUB DECK
SCRUB HEAD
The dual cylindrical scrub head is designed to scrub chemical into the carpet. The two counter rotating brushes raise the pile of the carpet, giving it a lush groomed appearance.
The rear brush is the stiffer brush and is intended to scrub deeper and help propel the machine. It can be identified by its black color.
The front brush is the softer brush and is intended to lift and groom the carpet pile. It can be identified by the white bristles.
MAINTENANCE
Scrub brushes should be replaced as a set when bristle length wears to height of yellow Perform AlertTM bristles.
SCRUB BRUSH REMOVAL
The scrub brushes are removed from the right side of the machine.
1.Disconnect all power and unplug machine.
2.Tip the machine back.
3.Pull out on the bottom of the retaining clip.
4.The brush assembly and end cap should drop down. Then pull the brush down far enough to clear the bottom of the housing.
5.Pull brush out with a rocking motion to free brush from drive hub.
SCRUB BRUSH REPLACEMENT
NOTE: See brush placement decal on brush deck. (Black brush to rear of machine and white brush to front of machine).
WARNING: Only use the brushes provided with the appliance or those specified in the instructions manual. The use of other brushes may impair safety.
1.Lift the drive side of the brush and push it onto drive hub until a positive stop is felt. The brush cannot be installed until the brush is fully seated on the drive hub.
2.Pull out on the bottom of the retaining clip.
3.Line up the end cap with the flats to each side.
4.Slide brush up into the retaining clip until it clicks in place.
86302100 CLIPPER DUO 05/08/08 |