3 Maintenance and Service
Any safety screen or guard removed for servicing must be replaced prior to operating the fireplace.
When properly maintained, your fireplace will give you many years of
Doors, Surrounds, Fronts
Frequency: Annually
By: Homeowner
Tools needed: Protective gloves, stable work surface
• Assess condition of screen and replace as necessary.
A. Maintenance Tasks-Homeowner
Installation and repair should be done by a qualified service technician only. The fireplace should be inspected before use and at least annually by a professional service person.
The following tasks may be performed annually by the homeowner. If you are uncomfortable performing any of the listed tasks, please call your dealer for a service ap- pointment.
More frequent cleaning may be required due to lint from carpeting or other factors. Control compartment, burner and circulating air passageway of the fireplace must be kept clean.
CAUTION! Risk of Burns! The fireplace should be turned off and cooled before servicing.
Glass Cleaning
Frequency: Seasonally
By: Homeowner
Tools Needed: Protective gloves, glass cleaner, drop cloth and a stable work surface.
CAUTION! Handle fixed glass assembly with care. Glass is breakable.
•Avoid striking, scratching or slamming glass
•Avoid abrasive cleaners
•DO NOT clean glass while it is hot
•Prepare a work area large enough to accommodate fixed glass assembly and door frame by placing a drop cloth on a flat, stable surface.
Note: Fixed glass assembly and gasketing may have res- idue that can stain carpeting or floor surfaces.
•Remove door or decorative front from fireplace and set aside on work surface.
•See Section 14.H for instructions to remove fixed glass assembly.
•Clean glass with a
-Light deposits: Use a soft cloth with soap and water
-Heavy deposits: Use commercial fireplace glass cleaner (consult with your dealer)
•Carefully set fixed glass assembly in place on fireplace. Hold glass in place with one hand and secure glass latches with the other hand.
•Reinstall door or decorative front.
•Inspect for scratches, dents or other damage and repair as necessary.
•Check that louvers are not blocked.
•Vacuum and dust surfaces.
Remote Control
Frequency: Seasonally
By: Homeowner
Tools needed: Replacement batteries and remote con- trol instructions.
•Locate remote control transmitter and receiver.
•Verify operation of remote. Refer to remote control operation instructions for proper calibration and setup procedure.
•Place batteries as needed in remote transmitters and
•Place remote control out of reach of children.
If not using your fireplace for an extended period of time (summer months, vacations/trips, etc), to prevent unin- tended operation:
•Remove batteries from remote controls.
•Unplug 3 volt adapter plug on IPI models.
Light Bulbs
Frequency: As needed
By: Homeowner
Tools needed: Protective gloves, replacement light bulbs.
•Remove the door or front from the fireplace.
•There are two square boxes hanging down behind the gas valve. These are separated into two pieces.
•While wearing gloves, grasp the sides of the box and slide the front/side portion towards you.
•The front will slide free of the rest of the box.
•Remove the bulb by pulling straight out.
•Reverse the steps to replace the bulb into the box.
Heat & Glo • | 13 |