Trane BMTK-SVN01D-EN manual Ethernet connection to PC workstation, Connecting over an existing LAN

®

Chapter 6 PC workstation wiring

Ethernet connection to PC workstation

Connecting over an existing LAN

To make an Ethernet LAN connection between the Tracker controller and a Tracker PC Workstation through an existing customer LAN, you need two CAT 5 patch cables.

1.Connect one end of the first CAT 5 patch cable to the RJ-45 Ethernet port on the bottom side of the Tracker controller (Figure 27 on page 52).

2.Connect the other end of the cable to an RJ-45 Ethernet wall jack near the controller.

3.Connect one end of the second CAT 5 patch cable to an RJ-45 Ether- net wall jack near the Tracker PC Workstation.

4.Connect the other end of the cable to the RJ-45 Ethernet port on the PC workstation.

Figure 27. Tracker Ethernet LAN connection to a PC workstation over an existing LAN

Tracker

Controller

RJ-45

Ethernet

LAN jack

CAT 5 patch cable

RJ-45 Ethernet

LAN port (bottom side)

Existing LAN

RJ-45 Ethernet LAN jack

CAT 5	RJ-45 Ethernet
patch cable	LAN port (back)

52 BMTK-SVN01D-EN