Hearth and Home Technologies CASTILE-MBK1, CASTILE-PMH1, CASTILE-CWL Listing and Code Approvals

Page 4

R

Castile Pellet Stove

1 Listing and Code Approvals

A. Appliance Certification

Model:

Castile Pellet Stove

Laboratory:

OMNI Test Laboratories, Inc.

Report No.

061-S-33-2

Type:

Solid Fuel Room Heater/Pellet Fuel Burn-

 

ing Type

Standard:

ASTM E1509-95, ULC S627-00 and ULC/

 

ORD-C1482-M1990 Room Heater Pellet

 

Fuel Burning type and (UM) 84-HUD,

 

Mobile Home Approved.

State Listing:

State of Colorado

E. BTU & Efficiency Specifications

Particulate Emis-

.7 grams/hr

sions Rating:

 

*BTU Output:

8,000 - 30,000 / hr

Heating Capacity:

up to 1,500 sq. ft. depending

 

on climate zone

Hopper Capacity:

40 lbs

Fuel:

Wood Pellets or Shelled Corn

Shipping Weight:

258 lbs

*BTU output will vary, depending on the brand of fuel you use in your stove. Consult your Quadra-Fire dealer for best results.

B. Mobile Home Approved

This appliance is approved for mobile home installations when not installed in a sleeping room and when an outside combustion air inlet is provided. The structural integrity of the mobile home floor, ceiling, and walls must be maintained. The appliance must be properly grounded to the frame of the mobile home and use only listed pellet vent Class “L” or “PL” connector pipe. A Quadra-Fire Outside Air Kit must be installed in a mobile home installation.

NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifications and/or price without notice.

C. Glass Specifications

This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.

NOTE: This installation must conform with local codes. In the absence of local codes you must comply with the

ASTM E1509-95, ULC S627-00 ULC/ORD-C-1482- M1990 (UM) 84-HUD

D. Electrical Rating

115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 Amps

Page 4

250-6422E

September 1, 2008

Image 4 Contents
Castile Pellet Stove Castile Pellet Stove Location Back side of left side panelTable of Contents Listing and Code Approvals Design, Installation & Location Considerations Fire SafetyGetting Started Appliance LocationInspect Appliance & Components and Pre-Use Check List Castile Pellet Stove Tools And Supplies NeededFire Risk 3Dimensions and Clearances Appliance DimensionsCastile Pellet Stove Clearances to Combustibles UL and ULC Castile Pellet Stove Hearth Pad Requirements UL and ULC Exception for Horizontal InstallationsHearth Pad Requirements Chimney and Exhaust Connection 4Vent InformationVenting Termination Requirements Pipe Selection Chart Castile Pellet Stove Equivalent Feet of PipeExample of 3 Elbow-Rear Vent Termination Calculaton See Figure5Venting Systems AlcoveDegree Straight OutCastile Pellet Stove Through The Wall Castile Pellet Stove Vertical Through The Wall & VerticalCastile Pellet Stove Masonry Alternate Masonry6Mobile Home 7Appliance Set-Up Outside Air Kit InstructionsTop Vent Adapter Installation Rear Vent and Rear Vent to Top Vent Adapter InstallationInstalling the Top Vent Adapter Castile Pellet Stove Leg Leveling SystemOptional TOP LOG Castile Pellet Stove Thermostat Installation 8Operating Instructions Fuel Size And Material General Operating InformationFire Characteristics Feed Rate Adjustment InstructionsCastile Pellet Stove Before Your First Fire Starting Your First FireFrequently Asked Questions Castile Pellet Stove Iginition CyclesSymption TroubleshootingPossible Cause Corrective Action Page Symptoms Possible Cause Corrective Action Quick Reference Maintenance Chart 10Maintaining & Servicing Your ApplianceFrequency Daily Weekly Monthly YearlyCleaning Firepot with Cleaning Rod & Firepot Scraper Cleaning Ash PanCleaning Heat Exchanger Chambers & Drop Tube Ash Removal from FireboxCleaning Beneath Heat Exchanger Cleaning the Exhaust PathCleaning the Hopper Cleaning the GlassCleaning Convection Blower Requires No Lubrication Cleaning Exhaust Blower Requires No LubricationCleaning the Top Vent Adapter Preparing Firebox for Non-Burn Season Frequency YearlyCastile Pellet Stove High Ash Fuel Content Maintenance Convection Blower ReplacementCombustion Blower Replacement Remove 6 screws Combustion BlowerIgniter Replacement Glass Replacement Component Function Vacuum Switch Wiring Harness See .1 belowSnap Disc #1 Convection Blower 110F Snap Disc #2 Fuel Delivery Interrupt 250FCastile Pellet Stove Component Locations Castile Pellet Stove Exploded Views Description Part NumberPart Description Castile Pellet Stove Service Parts and Accessories Service PartsCastile Pellet Stove Accessories AppliancesCastile Pellet Stove Service and Maintenance Log Date of Service Performed By Description of ServiceCastile Pellet Stove Service and Maintenance Log Cont’d Castile Pellet Stove Homeowner’s Notes Castile Pellet Stove Warranty Policy EPAHearth & Home Technologies Limited Warranty Cont’d T O T O Telephone