Harman Stove Company manual 30 P61A Pellet Stove

Page 30

Addendum

Minimizing Smoke during loss of Power using battery back-up

harmanTM strongly recommends installing battery back-up to minimize entry of smoke into the room in the event of power loss.

Your pellet/biomass burning appliance relies on a combustion blower to remove exhaust. A power failure will cause the combustion blower to stop. This may lead to exhaust seeping into the room. Vertical rise in the venting may provide natural draft. It is, however, no guarantee against leakage.

there are two harmanTM approved battery back-up options for your appliance:

uninterruptible Power Supply (uPS) UPS battery back-ups are available online or at computer and office equipment stores. Your HarmanTM appliance with Rev E or later software available beginning in November 2010 may be plugged directly into a HarmanTM approved UPS:

The APC (American Power Conversion) model #BE750G and the TrippLite model INTERNET750U are tested and approved. Other brands or models may not be compatible.

When power is lost, a fully charged UPS will power a safe, combustion blower only shut-down. Your appliance will pulse the blower every few seconds to clear exhaust until the fire is out. nOte: the uPS

provides safe shut-down only. it is not intended for continued operation.

Your appliance will recognize when power is restored. What happens depends on ESP temperature and whether it is equipped with automatic ignition:

in “Automatic” setting, units equipped with automatic ignition will respond to the set point and ESP temperature and resume normal operation.

in “Manual” setting or for units without automatic ignition:

If the ESP is cool, the appliance will remain shut down.

If the fire is out and the ESP is still warm, the feeder may restart. Since the fire is out, the ESP temperature will not rise. The unit will then shut-down, and may flash a six-blink status error. (See ESP error codes)

If the fire is still burning, it will resume normal operation.

Contact your dealer if you have questions about UPS compatibility with your appliance.

harman Surefire 512h battery back-up The 512H connects to a 12 volt deep cycle battery that will run your appliance for up to eight (8) hours. It includes a trickle charge feature that keeps your battery charged when power is available. nOte: if the power is out for longer than battery life, smoke

leakage may still occur unless your stove has been safely shut down.

cAutiOn! Always keep appliance doors and hopper lid closed and latched during operation and during power failures to minimize risk of smoke or burn-back.

cAutiOn! use only harmantM approved battery back-up devices. Other products may not operate properly, can create unsafe conditions or damage your appliance.

30P61A Pellet Stove

Image 30
Contents Installation & Operating Manual Safety NoticePage Label Table of Contents Important Notes Assembly and Installation Room Sensor InstallationInstallation InstallingMobile Home Installation With outside air installed, 6 feet VentingAddition, the following must be observed Outside Air Negative Pressure, Shut-down, and Power FailurePL Vent, Must Be Used VentingVent Configurations #1 Preferred method #2 Preferred method#4 Installing into an existing chimney #5 Installing into an existingFireplace chimney #6 Installing into an existing fireplace chimney #7 Installing into an existing chimneyMinimum flue vent configuration #8 Installing through the ceilingStatus light error messages Automatic Ignition ESP ControlRoom Temperature Mode Automatic IGNITION/OPERATIONStove Temperature Mode Feed Adjuster KnobShut Down Procedure Turn Feed Adjuster to #4.4 Igniter Switch to Auto up positionTurn Mode Selector to OFF Automatic Start UPManual IGNITION/Operation Igniter Switch to Manual down position Manual Start UPFill hopper with pellets and remove ashes as required.1 Low Draft Voltage Adjustment Low Draft Voltage AdjustmentMaintenance Glass ReplacementMinimizing Creosote Cleaning Scraping the burn potRemoving Ashes Not equipped with a fine dust filter may clog Disperse fly ash and soot into the roomSoot and Fly Ash Maintenance Burn Pot Burn Pot Cleaning and MaintenanceMaintenance Cleaning the Feeder Body Safety FeaturesFire has Gone OUT- Check for status light Trouble-ShootingCleaning Burn Pot Curing PaintFuel Specifications Fuel and Fuel StorageOperation in Stove Temp mode Operation in Room Temp modeChanges to Maintenance Schedule 30 P61A Pellet Stove Direct Vent Wall Passthrough Kit Side Heat ShieldsHopper Extension -Part#1-00-08636 Decorative Slate OptionsWiring Diagram SpecificationsLimited Lifetime Warranty Hearth & Home Technologies IncWarranty Conditions This warranty is void ifService Parts Part number list on following#2 Pre Serial number 008085092 Feeder Assembly Stocked at depot#3 Post Serial number 008085803 Feeder Assembly At depotStocked Clean Out Cover Sets 00-06623 P61A Pellet Service & Maintenance Log P61A Pellet Stove 42 P61A Pellet Stove Page Proudly Printed On 100% Recycled Paper