Planning & Installation Check List, Essential

PLANNING & INSTALLATION CHECK LIST

Unless you are knowledgeable and experienced in stove installation, we recommend your Glow Boy Appliance receive a Pre-delivery Check and be installed by your local Specialty Retailer, NFI (National Fireplace Institute) Pellet Specialist (USA) or WETT Certified Installer (CAN) .

COMPLETE THIS CHECK LIST PRIOR TO INSTALLING YOUR MULTI-FUEL APPLIANCE:

_____	Carefully read this "Owners Manual”. SAVE THIS MANUAL.
_____	Have your local Dealer demonstrate all the operational, cleaning and maintenance steps
	necessary for your stove.
_____	Select a location. The design of your home and the stove placement will determine its value
	as a source of heat. A pellet appliance depends primarily on air circulation to disperse its
	heat. There are other practical considerations, which must be considered before a final
	placement is decided on:
	Existing Chimneys, Pellet Fuel Storage, Aesthetic Considerations, Roof Design (rafter
	locations & roof pitch), Room Traffic, Clearances to Combustibles, and Existing Wiring.
_____ The installation of this appliance must conform to local codes and applicable state and
	federal requirements. Becoming familiar with these requirements before installation is
	essential.
_____	Sign and keep a copy of the Pre-delivery Check List supplied by your Authorized Dealer, OR
	“Dansons Certified Installer”, found inside our appliance or available online.
______	Attach your proof of purchase to this manual and keep on hand for warranty.

COMPLETE THIS CHECK LIST WHILE INSTALLING YOUR MULT—FUEL APPLIANCE:

_____	Carefully read the ENTIRE installation section first.	Twice is better.
_____	Read the Installing Freestanding, Insert or Built-In	sections.

_____ Determine the location and measurement needed your chosen location.

_____ Be sure to pre-fitall items before you install, fasten or install the stove permanently.

Remember measure twice, cut once.

_____ Ensure ALL joints of “PL” vent and single wall stainless steel liner are tightly connected,

sealed with RTV Silicone or Hi-Temp foil tape, including to the exhaust connector, and is correctly installed. (Follow vent manufacturer’s instructions.)

COMPLETE THIS CHECK LIST PRIOR TO LIGHTING YOUR FIRST FIRE:

_____	Obtain final inspection and approval by local building officials.
_____	Carefully clean all marks off the brass, nickel or pewter parts before the first fire is lit. Use a
	soft cloth and a gentle type cleaner. Caution: Never use an abrasive cleaner on any part of your
	stove.
_____	Polish the hopper to remove the oil type coating used in manufacturing.
_____ The high temp. stove paint used on your stove may take several hours of burning at a high fuel
	setting to fully cure. During this time an odor, which is not harmful, may be evident. The area
	around the stove should be well ventilated.
_____ Review and follow the Lighting and Controls Instructions.
_____	Ensure that appliance is connected to a surge protection unit.
_____	Fill the hopper with quality pellets, Close the Hopper Lid, Using the CCI “AcuTron”,
(figure 5), PUSH the FEED RATE Touch Pad and this will start the auger and the combustion fan.

Glow Boy Pellet & Biomass		www.glowboystoves.com	9