Lenovo 6530, 6523, 6524, 6525, 6522, 6526, 6528, 6529 manual Installing a security rope clip

1 Release lever

2 Hot-swap power supply

2.Using the handle, push the power supply toward the front of the chassis until it locks into place.

3.Connect one end of the power cord into the connector on the back of the power supply and connect the other end of the power cord into a properly grounded electrical outlet.

4.Make sure that both the ac and dc power LEDs on the rear of the power supply are lit, indicating that the power supply is operating correctly.

Installing a security rope clip

To help prevent hardware theft, you can add a security rope clip and cable to the server. After you add the security cable, make sure that it does not interfere with other cables that are connected to the server.

Before you begin, obtain the following items:

vA flat-blade screwdriver

vAn adjustable wrench

vA 19 mm (0.75 in.) rope clip or wire rope (similar to National Manufacturing number 3230, stock number 176-735)

vThreaded nuts that fit the rope clip

vA security cable

vA lock, such as a combination lock or padlock

To install a rope clip
1, complete the following steps:

1.Turn off the server and all attached devices. Disconnect all external cables and power cords.

2.Use a screwdriver to remove the two metal knockouts.

3.Insert the rope clip through the rear panel; then, attach and tighten the nuts.

66ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide