9.Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server.
Removing the rear adapter retention bracket
To remove the rear
1.Turn off the server and all attached devices; then, disconnect all power cords and external cables.
2.Unlock and remove the side cover (see “Removing the side cover” on page 32).
3.Remove all adapters (if necessary) and place the adapters on
Note: You might find it helpful to note where each adapter is installed before you remove the adapters.
4.Release the rear
5.Grasp the bracket on one side at the hinge point and pull inward (while you rotate the bracket slightly toward the front of the server) until the bracket 1 is free of the hinge pin 2; then, grasp the bracket on the other side at the hinge point, pull inward until the bracket is free of the hinge pin, and remove the rear
Installing the rear adapter retention bracket
To install the rear
1.Position the rear adapter retention bracket so that the hole in one of the hinge points is aligned with the hinge pin on the chassis; then, place the hinge pin through the hole on the chassis.
2.Rotate the rear
3.Install the adapters.
4.Install the side cover (see “Installing the side cover” on page 33).
5.Lock the side cover if you unlocked it during removal.
6.Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server.
86ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide
