8.Set any jumpers or switches on the drive according to the documentation that comes with the drive.
9.Remove the drive retainer clip from the side of the drive cage of bay 1 or bay 2. Slide the drive retainer clip to the front to remove it from the drive cage; then, snap the drive retainer clip into the screw holes on the side of the drive.
1 EMC shield
2 Tape drive
3 Drive retainer clip
10.Remove the EMC filler.
11.Push the drive into the bay.
Note: A tape drive can be installed in bay 1 or bay 2
12.Connect one end of the applicable signal cable into the rear of the drive and make sure that the other end of this cable is connected into the applicable connector on the system board.
13.Route the signal cable so that it does not block the airflow to the rear of the drives or over the microprocessor and dual inline memory modules (DIMMs).
14.If you have another drive to install or remove, do so now.
15.Connect the power cable to the rear of the drive. The connectors are keyed and can be inserted only one way.
Removing a hot-swap hard disk drive
This procedure applies only to server models that have
Attention: To maintain proper system cooling, do not operate the server for more than 10 minutes without either a drive or a filler panel installed in each drive bay.
