7.Squeeze the spring clips 1 on the sides of the front USB connector assembly and pull the assembly out of the back of the housing.
8.Carefully pull the front USB cable out of the opening in the chassis.
9.If you are instructed to return the front USB connector assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
Installing the front USB connector assembly
To install the front USB connector assembly, complete the following steps:
1.Carefully insert the front USB cable through the opening in the front of the chassis.
2.Squeeze the spring clips 1 on the sides of the front USB connector assembly and insert the assembly into the housing through the back of the housing.
3.Place the bottom edge of the housing into the bottom of the opening in the chassis; then, tilt the top of the housing into position until it clicks into place.
4.Reroute and connect the front USB cable to the front USB connector on the system board (see
5.Install the upper bezel (see “Installing the upper bezel” on page 37).
6.Install the lower bezel (see “Installing the lower bezel” on page 36).
7.Install the side cover (see “Installing the side cover” on page 33).
8.Lock the side cover if you unlocked it during removal.
Chapter 6. Installing and replacing customer replaceable units 85