Universal Adaptor Kit | 4 |
| |
An accessory adapter kit is provided with BD200MT. The |
| ||
|
| ||
adapter is compatible with many manufacturers’ accessories, | H |
| |
but if unsure, confirm with the specific manufacturer that their |
| ||
accessory is compatible. |
|
| |
| CAUTION: To avoid injury, do not use any accessory | Protrusion |
|
for an application where the adaptor may fail to hold the |
|
| |
accessory. |
|
| |
| CAUTION: Read and follow all manufacturers’ safety |
|
|
warnings for any accessories used with this tool. |
|
| |
| CAUTION: To avoid injury, ensure adapter and | 5 |
|
accessory are securely tightened. |
| ||
|
| ||
| CAUTION: Do not use this adaptor with Black and |
|
|
Decker accessories. Attach Black and Decker accessories |
|
| |
with the |
| J | |
this instruction manual. |
| ||
• | To attach, place adaptor plate (H) onto the oscillating tool | E | I |
| attachment with protrusions facing up as shown in Figure 4. |
| |
• | Place accessory on top of adaptor plate and fasten with the |
|
|
| bolt (E), press board (I) and |
|
|
| hex wrench as shown in Figure 5. |
|
|
•To remove, loosen the bolt and washer with the hex wrench, then remove the accessory and adapter.
Installing/Removing Accessories (BD200TMT & BD200MT)
•Some accessories, such as scrapers and blades can be mounted at an angle if required as shown in Figure 6.
•A triangle shaped base, or platen, uses a hook and loop adhesion system to attach the sanding sheets.
•Clean any residual debris from the tool shaft and the accessory holder.
•Position the accessory so the working edge is away from the tool as shown in Figure 7.
•Place the sanding platen on the front of the oscillating tool, ensuring the accessory fully engages the pins as described under “Assembly.”
•Align the edges on the sanding sheet, with the edge of the sanding platen and press the sanding sheet onto the platen as shown in Figure 7.
•Firmly press the base with the sanding sheet attached against a flat surface and briefly switch the tool on. This provides for good adhesion between the platen and the sanding sheet and also helps to prevent premature wear.
•When the tip of the sanding sheet becomes worn, detach the sheet from the platen, rotate and reapply as shown in Figure 7.
6 |
7 |
8