Brother Computerized Embroidery Machine operation manual

————————————————————————————————————————————————————

bCut the thread with the cutter on the left side of the machine.

1

aCutter

Note

zIf the thread is pulled through and cannot be cut correctly, lower the embroidery foot so that the thread is held in place before cutting the thread. If this operation is performed, skip step c.

zWhen using thread that quickly winds off the spool, such as metallic thread, it may be difficult to thread the needle if the thread is cut.

Therefore, instead of using the thread cutter, pull out about 80 mm (approx. 3 inches) of thread after passing it through the thread guide disks (marked “7”).

1

a80mm or more

cLower the presser foot lever to lower the embroidery foot.

dLower the needle threader lever on the left side of the machine until it clicks, and then slowly return the lever to its original position.

1

1

aNeedle threader lever

XThe thread is passed through the eye of the needle.

Note

zIf the needle was not completely threaded, but a loop in the thread was formed in the eye of the needle, carefully pull the loop through the eye of the needle to pull out the end of the thread.

CAUTION

●When pulling out the thread, do not pull it with extreme force, otherwise the needle may break or bend.

1

aPresser foot lever

Upper Threading 33